Reply to thread

Message

<blockquote data-quote="DolanDuck93" data-source="post: 23718717" data-attributes="member: 420926">Hey Y&#039;all,I&#039;ve got this boro mod (second hand) that i equipped a Ether V2 RBA with that&#039;s always reading the ohms around 0.2 higher. Eg. it will read at 0.35 on the ohm tab and 0.55 when firing it. Sometimes the ohms will jump to 1.0 but whenever it is firing it will go back to 0.55To my knowledge this mod uses the Dani Extreme V3 Chip by Dicodes.I&#039;m not so sure if it&#039;s supposed to be jumping around so much. And wondering if this is an issue? Because i heard that in regulated mods ohms do not matter much.I find that this mod eats through a fully charged 18650 faster than my other mod which is a dotmod dotAio v2 which is running the exact same coil and same wicking method. Though my dotmod which was a first hand item seems to have better flavour and vapour production.Could it be because the mod thinks that it is a 0.5 ohm coil hence the battery drains faster?Specs used : Coil : BP Mods Clapton Coil 26Ga A1 x 2 + 40Ga Ni 80Coil ID : 2.5mmWick : Muji CottonBattery : Molicel P28DotMod Specs : Dotshell RBAI run both devices around 38 watts. Would also like to note that the dotmod is reading the ohms correctly at 0.35 ohms on the same coil. And i notice the battery drain is slightly slower than the CBOT.Any sort of feedback would be appreciated, Thanks!</blockquote>

[QUOTE="DolanDuck93, post: 23718717, member: 420926"] Hey Y'all, I've got this boro mod (second hand) that i equipped a Ether V2 RBA with that's always reading the ohms around 0.2 higher. Eg. it will read at 0.35 on the ohm tab and 0.55 when firing it. Sometimes the ohms will jump to 1.0 but whenever it is firing it will go back to 0.55 To my knowledge this mod uses the Dani Extreme V3 Chip by Dicodes. I'm not so sure if it's supposed to be jumping around so much. And wondering if this is an issue? Because i heard that in regulated mods ohms do not matter much. I find that this mod eats through a fully charged 18650 faster than my other mod which is a dotmod dotAio v2 which is running the exact same coil and same wicking method. Though my dotmod which was a first hand item seems to have better flavour and vapour production. Could it be because the mod thinks that it is a 0.5 ohm coil hence the battery drains faster? Specs used : Coil : BP Mods Clapton Coil 26Ga A1 x 2 + 40Ga Ni 80 Coil ID : 2.5mm Wick : Muji Cotton Battery : Molicel P28 DotMod Specs : Dotshell RBA I run both devices around 38 watts. Would also like to note that the dotmod is reading the ohms correctly at 0.35 ohms on the same coil. And i notice the battery drain is slightly slower than the CBOT. Any sort of feedback would be appreciated, Thanks! [/QUOTE]

Verification

Search

Search

Reply to thread