*sigh*ordered an MVP, yep Kim, you are right
Before I got a chance to jump in and say that I didn't like the shape either, but I wanted the battery life, so I got one a couple of weeks ago. And my second one shipped today.

*sigh*ordered an MVP, yep Kim, you are right

That's the one I got! LOL great minds think alike![]()
Is 40 too young to hang out on the porch and have a vape with y'all? I promise I'll behave...well try
Anyhoo, due to some unfortunate genetics, I found myself needing dentures a few years ago. I currently find myself coming off my first experience with the dreaded Vaper's Tongue. At least I hope I'm coming off, it's been a horrible week. I was wondering however, I know having this chunk of plastic across my palate reduces flavor. And I rarely sleep without them (yes, I'm that vain...sigh). I did last night though (hubby is away with a military thing so noone to look good for) and it seems I can taste better. Do these things make VT worse? or increase potential for getting it in the first place?
I also have a horrid habit of clenching my teeth all day, I'm sure that isn't helping with the epic dry mouth I have. Tips? Tricks?
Biotine will help with the dry mouth.
As far as the Pro-whatsit...
I got min to celebrate the milestone of finally breaking even vs smoking. In fact, after paying provape $301, I'm still in the black by $49!
But only if I don't buy anything vape related by the end of the month.
So, on Sunday, I'm going to open the package, take some pictures to post and have it with me on Monday!
) and my tank was gurgling. No biggie, just take soft pulls while I'm driving around. Deliver a couple of papers, get back in the car, grab my Zmax and its just covered in juice! No reason that it would leak other than it was getting low, and this is one of my favorite tanks. Not as good as my protank clone, but one I really like. I can get rebuilt Vivi Novas for $5 at the B&M, so I think I'm sticking with those for a while!So I somehow managed to bend the base of my protank so that it shorts out, oh well, gives me a reason to buy an aerotank base for it
Last stinky October 15, 2013
I really think I'm done with bottom coils! I was doing my paper route (a dream I've had since I was 10) and my tank was gurgling. No biggie, just take soft pulls while I'm driving around. Deliver a couple of papers, get back in the car, grab my Zmax and its just covered in juice! No reason that it would leak other than it was getting low, and this is one of my favorite tanks. Not as good as my protank clone, but one I really like. I can get rebuilt Vivi Novas for $5 at the B&M, so I think I'm sticking with those for a while!
Another mech. I wish you guys would quit making me get all these.
HCigar Kylin (pisces-t clone). Surprisingly small compared to the others I have using the same batteries. This is 18500. The switch needs some serious work, look at that gap.
![]()
It's a spring. It would take some abstract size magnets. I think I'll sand down the delrin ring if I can figure out how to get it out, it looks pressed in. It's really not too bad I'm just spoiled by my nemesis and M16, got those down to about a mm.
Harden a coil: Heat the coil to very hot. Like glowing. Then quench in clean water. That hardens it. Too much and it will become brittle and you will need to temper it again.If it's a stiff spring - you can 'torch it' to remove some of the temper to make it a bit easier to press. I've just lightly torched each coil of the spring 'till it just starts to glow, then move the torch to along the spring. But be careful if you do this, there's no reversing it if you weaken it too much.

Look what I found: The Omnitester at MadVapes.
It's supposed to check resistance, check voltage (including on eGo batteries), and check voltage drop. Plus, it's rechargeable. Sounds too good to be true for only $15. I hope not. I ordered one just minutes after I found out about it!
ETA: Now the link says "out of stock". I guess I'm not the only one!
I am over 50 years young and I vape.
Good to see that there are others like me.![]()
If it's a stiff spring - you can 'torch it' to remove some of the temper to make it a bit easier to press. I've just lightly torched each coil of the spring 'till it just starts to glow, then move the torch to along the spring. But be careful if you do this, there's no reversing it if you weaken it too much.
I am over 50 years young and I vape.
Good to see that there are others like me.![]()
I agree !!!!
Hello everybody.
I am over 50 years young and I vape.
Good to see that there are others like me.![]()
I really think I'm done with bottom coils! I was doing my paper route (a dream I've had since I was 10) and my tank was gurgling. No biggie, just take soft pulls while I'm driving around. Deliver a couple of papers, get back in the car, grab my Zmax and its just covered in juice! No reason that it would leak other than it was getting low, and this is one of my favorite tanks. Not as good as my protank clone, but one I really like. I can get rebuilt Vivi Novas for $5 at the B&M, so I think I'm sticking with those for a while!