Here I go again, looking to you all for noob help. I have read about dripping to taste new flavors, but how do I do this? What do I need to do, or have? I ordered in some sample juices and I sure don't have enough tops for each flavor or want to waste a lot it!
One of the easiest ways is to get an atomizer made for dripping. A common one is the 306 dripping atty. The Cisco 306 is among the best as well as the IkenVape I06 but also pricey. Something like this is reasonable.
Bauway 306 LR 1.5ohm Bridgeless Atomizer- Sealed
You also need a 306 drip tip - the common 510 drip tips will not fit a 306 atty.
http://www.silogic.com/Athena/photos/Chris%20Hausler/Wean%20Hall%20-%20IBM%20360%20and%20Univac%201108/1%20Univac%20Tape%20Drives.jpg
If you only have one for tasting - You can rinse these with hot water or everclear/grain alcohol (not isopropyl )between flavors. Or you can vape some unflavored PG or VG between flavors. But not all flavors flush out easily w/o leaving some residual taste.
You can also do it w/ any 510 atomizer - but the atty built for dripping do work better dripping.
If you want to jump in the deep end of the pool right away. Something like an Igo-L rebuildable dripping atty is inexpensive and easy to flush with hot water, pat dry, and move to the next flavor.
Hope this helps - I'm sure others will respond too.
edit: if you buy from Stormy, use coupon code = 10OFF!