One side has 6 wraps and the other 7

[Ben85]

@dethmedalmuziq You need to start using the steam engine site yourself. That way, you won't need to ask such questions.

Good luck.

 

[Eskie]

@dethmedalmuziq You need to start using the steam engine site yourself. That way, you won't need to ask such questions.

Good luck.

It's funny. I've been building for a little while, certainly not nearly as long as some of the veterans around here. My builds are typically much the same. Yet I still run every build through Steam Engine just to double check before building. It takes a few seconds and I can be sure I remembered the number of wraps correctly. A very low effort step in rebuilding a deck to assure all will be good.

 

[Bunnykiller]

Can I use my rda with one side 6 wraps and the other side 7? I used kanthal 24g and the build is 3.5-4.0 ohms. I'm new and it's my second build I ever did.

24 gauge wire ( kanthal ) is .172 ohms per inch. for a dual coil ( parallel build) you would need 46" of wire per coil to create approximately 8 ohms per coil which in parallel would be 4 ohms...

check your numbers again...

 

[mikepetro]

Crossposting because its important...

OK, Evolv finally published this data publicly now about the spike of formaldehyde and Acetaldehyde spiking like a sky rocket very quickly, double what is found in a cigarette, starting around 470F-480F.

Temperature Control is IMPORTANT folks!

Start about 6 minutes in: