Original CE2 Cartomizer 510 regular on a 510 manual battery

[cricque]

Hello,

I wanted to order some CE2 Cartomizer just to try it out, after 3-4 weeks of vaping
Now some shops just sell them other ask at which ohms you want them at ?

I have bought a joyetech 510-t kit with normal manual batteries (180maH)

So at what ohms should i get this ?

2.4-2.6
2.6-2.8
2.8-3.0
3.2-3.5

As I can understand 2.4-2.6 should be the good one to get ? Or am I completely wrong with this

Thanks in advance for the reponse

 

[440BB]

You're right! Either that or the next higher would be fine on a 510. Anything higher will be probably be better on a higher voltage unit at it will provide limited vapor and heat on a 510. Good luck!

 

[cricque]

Thanks for the quick reply, it just can get confusing. But apparently I am starting to get the hang of it

So basically if i would take 2.4-2.6, this would be spot on. 2.6-2.8 would make it heat up a bit more and perhaps cause more vapor/th

 

[440BB]

Actually the opposite - lower resistance (ohms) burns hotter. Since the 510 is regulated to about 3.4 volts it can support a lower resistance without burning too hot. If you used a higher voltage device, say 5 or 6 volts, then a higher resistance carto is in order or it would burn the carto easily. Lower ohms = burns hotter, so keep it wet! With the Ce2 it helps to tip it up once in a while to get the liquid wicked up to the coil, which is on top.