parallel box unregulated

[Ghost085]

Just a quick question. Is it ok to use a tank with a high wat rating on an unregulated parallel box and not recieve a warm hit using stock built coils?

 

[State O' Flux]

Perfectly fine... although depending on the wire gauge and other variables, the discharge may be a bit "light".
Unlike a high-watt regulated mod, you can't "force" wattage to a value above Ohm's law, net resistance parity.

Use the Ohm's law formula (V² ÷ Ω = P, where P equals wattage) to determine your actual device draw in watts.

 

[Robino1]

Moved to New Members from Simple Solutions
Simple Solutions is to assist the Beginning Vaper with getting started

 

[fattmatt805]

Perfectly fine... although depending on the wire gauge and other variables, the discharge may be a bit "light".
Unlike a high-watt regulated mod, you can't "force" wattage to a value above Ohm's law, net resistance parity.

Use the Ohm's law formula (V² ÷ Ω = P, where P equals wattage) to determine your actual device draw in watts.

pretty sure power is Volts x Amps = Watts

 

[fattmatt805]

spoke too soon, your formula works just fine! I have never seen it that way before

 

[Thrasher]

You'll get used to it lol.

Were big on safety and ohms law and all that mathy stuff here.


If you haven't been here already here's a handy bookmark

Steam Engine | free vaping calculators

 

[fattmatt805]

You'll get used to it lol.

Were big on safety and ohms law and all that mathy stuff here.


If you haven't been here already here's a handy bookmark

Steam Engine | free vaping calculators

i LOVE steam engine, been using it since i started building. I'm all about safety, and try to avoid pipe bombs as much as i can! lol

 

[Ghost085]

I am still learning myself. I use a regulated box with my kanger mini rba build my coils on it with 26 gauge 4 wraps at about .4 ohms

 

[Cullin Kin]

spoke too soon, your formula works just fine! I have never seen it that way before

Just going to put this here...