I need a feeding tube for my Grand.It is my only P.V at the moment. I need to know do I have to order one ,send it to him or what. Also if I can get one is it easy to replace.
Please help i need a feeding tube for my grand
- Thread starter lurchensteen
- Start date
- th_trl_thread_readers 0
- Status
If it is leaking at the top of the tube, you may be able to just cut off the affected portion. It will be shorter, and not go to the bottom of your juice bottle, but it would hold you over while a replacement comes in.
I am not sure what happened to it. I filled the bottle one day and went to feed it and was only getting air. I opened the door and found juice every where inside. cleaned it out and cleaned the tube and as i was cleaning i saw where it was leaking. how would I go about getting a new one?
Also if it is split at the top, you can simply pull it off and turn it upside down so the split end is at the bottom. Again, this is temporary, but it will keep you up and running. 
I answered your post in the Mods Discussion forum, but Rob will take care of you.
i was wondering that. my mom had her mini re-built and it came back with the thicker tubing. its a good thing cause man o man is she rough with the little thing lol.
Sorry for the last update. Rob got back to me about the feeding . I ordered a new tube from the site. Thank again Rob and everyone for the help.
I hope this is appropriate to this thread.
I recently had the tube on my grand upgraded by Robert when I sent in for a button issue. However when I went to fill my bottle, the tube pulled of the brass nipple. I have figured out how to maintain pressure on the tube to help keep it from slipping off but wondered if these are typically glued on with the newer design. I only ask because a newly purchased grand has no issue with tubing slippage. Any advise would be appreciated. I'm hesitant to use super-glue without permission.
I recently had the tube on my grand upgraded by Robert when I sent in for a button issue. However when I went to fill my bottle, the tube pulled of the brass nipple. I have figured out how to maintain pressure on the tube to help keep it from slipping off but wondered if these are typically glued on with the newer design. I only ask because a newly purchased grand has no issue with tubing slippage. Any advise would be appreciated. I'm hesitant to use super-glue without permission.
I hope this is appropriate to this thread.
I recently had the tube on my grand upgraded by Robert when I sent in for a button issue. However when I went to fill my bottle, the tube pulled of the brass nipple. I have figured out how to maintain pressure on the tube to help keep it from slipping off but wondered if these are typically glued on with the newer design. I only ask because a newly purchased grand has no issue with tubing slippage. Any advise would be appreciated. I'm hesitant to use super-glue without permission.
Try flipping the tube over and slipping it on from the other end. If that doesn't stay on, use a small drop of super glue and give it time to cure.
- Status
