Please Help

[lilpring]

My smok Xcube 2 doesn t turn on. So i opened it up and i saw a loose red cable. Anyone know how i can put it back in place safely? Thank you!?

 

[daviedog]

Go to manufactures website & request a wiring diagram. May use Google search.
Once you know where the wire goes, you may solder it..

 

[BrotherBob]

Welcome and glad you joined.
Might like to read:
Beginner | Guide To Vaping
ECigarette Academy: Essential Need to Know for New Vapers
One Stop Reference Shop For New and Experienced Vapers
The Vapers Table
(10) Advancing Up the Vaping Ladder with Egos and Mods | E-Cigarette Forum
(4) Good Starter Setups for a Beginning Vapor | E-Cigarette Forum

 

[lilpring]

Go to manufactures website & request a wiring diagram. May use Google search.
Once you know where the wire goes, you may solder it..

Ok. Thank you

 

[sawlight]

I found this, not sure how much it helps, but it shows a loose wire in the pics.

 

[Eskie]

That photo shows the black wire soldered to the Bat-, and the red wire is right by the Bat+, which looks to have excess solder on it. My bet, that's where it goes. My advice, check with the manufacturer whether that is correct then solder away.

Edit: (10 AM EDT) I needed more coffee this morning. I saw the above photo and thought it was from the OP, until looking at it again after my third cup and realizing one, @sawlight was not the OP, and two the pic sawlight posted was a DIY shot which was even labeled as the Bat+ wire. So, basically, nevermind........

 

[lilpring]

Thank you everyone but i cant get it to work