I got an authentic plume veil 2.0 today, and can not figure out how to adjust the drip tip air flow. any one have any idea here? I can unscrew the drip tip but it doesn't change the airflow any and I'd like to close it off some.
RDA Plume Veil 2.0 airflow drip tip airflow adjustment
- Thread starter dragonsdeath
- Start date
- th_trl_thread_readers 0
- Status
You have to make sure that your drip tip is very tight in that delrin piece. Sounds like you're just spinning the drip tip inside of that piece.
When I was using my Plume, I had a vape Smith Goblet drip tip and it was very tight and opened/closed the top air flow when I turned the drip tip.
When I was using my Plume, I had a vape Smith Goblet drip tip and it was very tight and opened/closed the top air flow when I turned the drip tip.
np man, there seems to be no info on the 2.0. googled it and got nothing. Even the Aethertech web site doesn't show it, but I know its authentic. Vapor Range where I got it seems to be the only place with them right now.
Actually did find it for pre order on a few sites.
Actually did find it for pre order on a few sites.
Last edited:
I did not know there was a plume veil 2.0 I only know of the 1.5. On the 1.5 you just turn the drip/delrin piece counter clockwise. It lowers the piece and opens the two top air holes. In my experience the difference is not super noticeable.
Screw the drip tip all the way out and puch it through the bottom, then you can push the delrin air-flow adjustment ring out of the top of the top-cap. It has 3 positions in which you can change the air-flow, along with the tip adjustment! I hope this helps!
You can actually screw the drip tip inward until the milled line on the tip is level with the black delrin topcap overlay, they push it out from the underside of the topcap. Don't worry, the flange on the bottom of the drip tip will keep the stubborn thing from flying off!!
No problem! Would you mind sending me pictures of your V2 along with the packaging? Just making sure mine is authentic. Thanks!
Mine is identical, just a different serial #. Unfortunately the center contact pin was cross-threaded from Aethertech so i have to find a replacement bottom cap and 2 screws for it because it only came with 2. Haven't put a build on it yet, but i think i like my 1 and 1.5 better already!
I haven't seen a 1 or 1.5 in person. This is by far my most expensive rda. Only Authentic prior to this have been Doge and mutation x v3.
Plus you control airflow through the cap by the height you have the tip set at, just twist R or L, instead of popping the damn thing out! I have a feeling I'll be sticking to the V1.5. Gotta find a V1.2 to finish the collection! Lol
Lol, after figuring out the top cap air flow, this thing is amazing. Has def replaced my Doge v2 as my favorite rda.Really? Trade ya.
My Dark Horse I got the next day comes in second. Hate the Mutation x v3 I got a few days prior, and they are all Authentic.
Plus 169 is a pretty low sn. I'm just starting to get authentics after selling all my clone gear, and wile not a sn junkie it's kinda cool having a low sn on a Plumeveil
- Status
