Plz help

Status
Not open for further replies.

Bonskibon

Vaping Master
ECF Veteran
Verified Member
Dec 11, 2015
3,589
8,400
You will see a round disc in the center of this end. This is the center post. Use a thumb tack, paperclip or similar object. Stick it in between the center post and the battery threads and gently raise the center post.
MG_0206_large.jpg
 

Sugar_and_Spice

ECF Guru
ECF Veteran
Verified Member
Sep 11, 2010
13,663
35,225
between here and there
I have just plugged my E-cig and the light on the charger has turned red but then when I hold the button on the E-cig the light on the charger then turns a yellow or gold colour
Red light = charging....should leave it on the charger until the light turns green.

If still nothing....then Bonskibon is correct it is not making a connection. Take the tank off. If you have already lifted the center post on the mod, then look at the very bottom of cartomizer tank where the connection(pin) is. If it has a slit running though it like the top of a screw try turning it a little to the left. The object is to lower it but not pull it out. If the cartomizer has a smooth bottom that does not look like a screw, see if you can pull that little plate down a little to help the connection meet.
 

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
14,205
12,497
Sunnyvale,CA,USA
My kangertech evod light won't turn
Welcome and glad you joined. Could also try three additional avenues of inquiry:
Local Vape Shop -----Might be simple.
Vendor who sold it ---see if they will repair or replace or advise.
Manufacturer contact ---
KangerTech US--Atlanta, GA--888-799-1988
Hours of Operation: Mo-Fr: 9:00am-5:30pm EST
Could check distributors on the Kanger site.
 
Status
Not open for further replies.

Users who are viewing this thread