Potential Atty Issue

[windmiller]

Day two of use of an atty and am seeing an odd issue.

I use 3-4 drops but there is still a very slight chemical/burnt metal taste. I'm getting maybe 3 good hits before I get a really really chemical/burnt metal taste. Is this normal?

If I need to order a new atty for my SLB KGO what should I get?

 

[Huffelpuff]

2.0 ohm 510 connection. You can order from any vendor that you would like. I use ECF approved vendors as they are accountable for quality and service.

I found some for you to look at here: Atomizers and cartridges

You may want to try using a bit of compressed air to blow out your atomizer from the battery end and let it sit for a few hours in front of a fan. If its just gunked you may be able to resurrect it. Try that then put 3-5 drops and let it sit for a few minutes.

 

[windmiller]

Hoosier is where this atty is from. Looks like this is common behavior. I shined a flashlight into the atty and found black fibers, I pulled the black fibers out and tried it again and the atty doesnt work at all now. Based on the post below I burned up the wick but not sure how this happened.

So is a bridgeless atty better for a KGO?


http://www.e-cigarette-forum.com/fo...zer-dripping-kgo-1100mah-4-0v-under-load.html

 

[SCTony]

My very first atomizer was bad too- kind of put me off of dripping at first. In mine, I think the coil was not seated properly and I only got one or two good puffs and then the burnt taste. My second atty is working much better. The first one was LR Boge 2 ohm and the second one is Standard Resistance Boge 3 ohm. I am using a KGO too. Cheers!

 

[classwife]

Moved to Atomizer, Cartomizer and tank Discussion

 

[windmiller]

My very first atomizer was bad too- kind of put me off of dripping at first. In mine, I think the coil was not seated properly and I only got one or two good puffs and then the burnt taste. My second atty is working much better. The first one was LR Boge 2 ohm and the second one is Standard Resistance Boge 3 ohm. I am using a KGO too. Cheers!

Exactly what happened to me, first couple puffs and then nasty.

Man, there are so many atty and cartomizer options it's insane. Now I've got a busted atty and about 15 juices to try. EmpireMods has a nice selection of atomizers....any recommedations for which atty to get for dripping?


LR Atomizers

 

[SCTony]

Well I don't have much experience- I am new too. I see that there are a LOT of variables that need to fine-tuned for each individual. Flavor seems to come through better at certain voltage/resistance combinations. Kgo works at ~3.7 volts so maybe a standard resistance atty gives better flavor? Then there is the viscosity of the juice and how well it flows through the filler-and/or-wick-and/or-atomizer mesh. AYE YI YI will it ever come together!? lol I aint going back to analogs that's for sure Cheers!