RDA Praxis Derringer Anyone?

[personalvoid]

Also, one downside is that it doesn't sit flush on the 520 connector of my hana. As apparently the centerpin is too prominent and the spring loaded pin of the hana v4 simply cannot accomodate it. Couple of pictures to show you this.

Do you advise to sand the centerpin? After paying full price for this i am not sure i want to mess with it...

 

[Libbydude]

Also, one downside is that it doesn't sit flush on the 520 connector of my hana. As apparently the centerpin is too prominent and the spring loaded pin of the hana v4 simply cannot accomodate it. Couple of pictures to show you this.

Do you advise to sand the centerpin? After paying full price for this i am not sure i want to mess with it...

View attachment 479437

Well, since you paid for it I would go ahead and sand it down.

If I paid for it I would not want to. I would put a low build on it and run it on a mech that could accommodate the pin. But I'm ocd.

 

[personalvoid]

This build requires a certain degree of skill... 0.17 ohm temp control 32 gauge nichel200 11 wraps dual coil........... Lets vape guys!!!!