Prewired 510 connectors

Status
Not open for further replies.
doubt you will find pre-wired ones. i have yet to see any place that has them.

i use speaker wire. i try not to take off to much of the plastic because i don't want it shorting. that does make it a little tougher.

the nice thing about speaker wire is, you can actually grab the bottom of the wire and with your other hand pull twards the connection you just made and it will stretch the plastic over anything exposed. no need for heat shrink.
 

gpxfiles77

Full Member
May 7, 2010
15
0
55
West
Thank you peopel for your answers. I was not notified that I had recieved replies by email. I did give up trying to find wired versions and ended up buying solder paste, a torch lighter. I punch a nail through some electrical tape folded twice, trim with sissors such that it is a washer about the same diameter as the nail head. Stick the nail in there and thread atomizer on top of it. Take one wire, strip 1", twist around outside of 501 connector, squirt some solder paste on it, melt it with torch. Same with the pointy end of nail. Now I vape with that hooked to 4' of speaker wire like the gentleman above which is hooked to a 4 pack AA nimh batteries going at around 5V. Looks kind of stupid but vapes much better.
 
Status
Not open for further replies.

Users who are viewing this thread