Problem with Baby Beast TFV8 RBA

[CupcakeGirl94]

Hello, guys. I was a bit tired of buying new coils every single day so last week i bought the RBA one. Now here are the problems.

Im really bad at building but i never had such a problem. Im getting 0 ohms and ''Ohms too low'' everytime when i press the fire button. Tried at least 5-6 times and it was always the same so im asking you what im doing wrong. Btw, im using pre-maded coils. I have 0.15 alien coil by LD and eleaf Clapton 0.85

Here are some pics

 

[Fidola13]

Not sure if it’s my phone but I can’t see the photos.

 

[bombastinator]

Ohms too low means you have a short

 

[CupcakeGirl94]

Not sure if it’s my phone but I can’t see the photos.

https://i.imgur.com/5rNzxDz.jpg

https://i.imgur.com/ERSCh0y.jpg

https://i.imgur.com/tTn0eN7.jpg

https://i.imgur.com/VBXFxoZ.jpg

 

[Shawn Hoefer]

Judging from the pics, your coils are too large and making contact with the chamber top when you screw it on creating a short. For the Baby Beast RBA, the largest your coils should be is around 2.5mm in diameter. You can drop the coils onto a 2.5mm mandrel or screwdriver, and grab both ends with a pair of pliers and pull to shrink the coils down a bit.

 

[Zaryk]

I have to agree with Shawn, your coils look too big and are likely shorting out on the chamber walls. Smaller coils should fix it. If you want the same ohms, do as Shawn mentioned and try to put an extra wrap on after shrinking the coil inner diameter.

 

[RayN]

I'm new at this rebuilding stuff. Shouldn't the coils be exactly the same though? Are you using the .15 and .85 at the same time?