problem with flavors and taste (vamo+vivi)

Status
Not open for further replies.

sivo

Senior Member
ECF Veteran
Mar 8, 2013
128
16
44
Montreal
Am I doing something wrong? i taste some flavor at first when i fill my vivi, but after a little bit it starts to taste kind of dry and dull, using one of my new vision vivi's with a 2.4 head reading at 2.5 ohms on my vamo, using a RY4 juice, 70/30 pg/vg, 20 nic. it has happened with other flavors too.

also, i am vaping at 4.2 volts, should i turn it up or down?
 

Vapoor eyes er

ECF Guru
ECF Veteran
Sep 13, 2011
11,028
8,945
Toronto, Ont.
Am I doing something wrong? i taste some flavor at first when i fill my vivi, but after a little bit it starts to taste kind of dry and dull, using one of my new vision vivi's with a 2.4 head reading at 2.5 ohms on my vamo, using a RY4 juice, 70/30 pg/vg, 20 nic. it has happened with other flavors too.

also, i am vaping at 4.2 volts, should i turn it up or down?

Haven't gotten my Vamo yet but have used VV. Right now I use 1.8 ohms heads at 4- 4.2 volts. What I would suggest is turn the voltage up until you hit your "sweet spot" with that juice- other juices may need lower or higher voltage.

Edit: 2.4 ohms @ 4.2 volts is kind of the low range for that ohms/ head.
 

Kanj.nguyen

Ultra Member
ECF Veteran
Verified Member
Jan 18, 2013
1,874
1,754
Princeton, NJ
Unfortunately by design, the Nova will dull your flavor.

HOWEVER, before you go and buy some expensive stuff to replace the Nova, keep in mind that you may have Vapers Tongue which will go away in a few days. I did at first, and after that my Novas worked fine.

In terms of flavor, on the scale of 10, 10 being dripping, then genesis atty is a 9 and Novas are around 6.5-7. Which, honestly, are not bad.
 

Clearo-Mizer

Super Member
ECF Veteran
Jan 21, 2013
588
449
59
Woodstock Ga
I concur...i run my novas with the 2.4 coil at around 7.5-8 watts..

thats watts not volts but with a Vamo you can run in wats mode ...then you dont really have to worry about volts..it will run at the wats you set regardles of what ohms your coil is...that why i love the Vamo, watts and volt control
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread