Problem with my spinner...or EVOD.?

[jenmurray116]

Hi everyone - I'm using a vision spinner and had a regular CE4 on it and it was fine. Went to switch it to my EVOD and it wouldn't work - it just flashed a few times. Put the CE4 back on the spinner, and it's fine. Pulled out an ego twist and put the Evod on it, and it's fine. Evod on spinner, nothing - just flashes....? I'm sure I've used them together before - why would they not play nicely today, but each work with other things? After a major equipment failure last weekend, I do tend to be a little nervous about this stuff - and aside from the CE4, all my stuff is less than 2 weeks old. I'm still a novice so I'm a little confused here - any thoughts??

 

[MayLovesMetal]

I had spinners and a kgo which would sometimes not make an adequate connection with certains delivery systems when I first started vaping- something about the center posts. My hardware vendor at the time advised me to take something like a small flat screwdriver, or maybe a pair of tweezers and gently pry around the edges of that post which worked. I'm not familar with Evod but might be worth a try. =)

 

[jenmurray116]

huh - funny enough (to me!), it seems to have been a juice issue....I didn't realize the juice level in the Evod was low. Once I added more, it worked fine in the spinner. Odd (again, to me) that it would work with the twist but not the spinner. This brings up another observation, though....since going from my apparent knockoff's and mainly CE4's to mainly the Spinners with Evod's, I am going through double the amount of juice that I used to! I'm not sure if that's the equipment....or me....

 

[Unforeseen]

Moved to Variable Voltage APV Discussion

 

[crxess]

It is you. You now have a device(Evod) that can deliver and no doubt you are getting the most out of it.

 

[retrox]

Spinner + eVod is a fantastic combo (check my avatar )! One thing to keep in mind with the eVod, though: Always check, anytime you're cleaning or refilling, that the head assembly is screwed down firmly into the base. They tend to work themselves loose if you're not paying attention. Symptoms of a loose head assembly could be slight leakage or inconsistent contact between your battery terminal and the positive post on the head.

 

[thxone]

Hi everyone - I'm using a vision spinner and had a regular CE4 on it and it was fine. Went to switch it to my EVOD and it wouldn't work - it just flashed a few times. Put the CE4 back on the spinner, and it's fine. Pulled out an ego twist and put the Evod on it, and it's fine. Evod on spinner, nothing - just flashes....? I'm sure I've used them together before - why would they not play nicely today, but each work with other things? After a major equipment failure last weekend, I do tend to be a little nervous about this stuff - and aside from the CE4, all my stuff is less than 2 weeks old. I'm still a novice so I'm a little confused here - any thoughts??

My Vision spinner was doing this as well, oddly with my EVOD. I don't think it is the EVOD... Get a good Q-Tip and some rubbing alcohol, dip the Q-tip in the alcohol then clean inside the connection on the spinner with firm pressure as you move the Q-tip around the inside of the connection. Also clean the contact in the center. Now use the dry side of the Q-tip and repeat the same motions as when you cleaned it. Make sure it is dry and re-try the EVOD. This fixed my flashing button. Also, I backed of my EVOD until the button stopped flashing... this told me the connection was dirty. Hope this helps.