Protank 2 need help

[Outcast]

Got my pt2 today I like it a lot getting Burt hits off it I'm vaping at 7.5watts any ideas

 

[Elex300]

What pg/vg ratio are you using? You can remove a wick from the coil. If you remove that top stem on the coil head you will see 2 flavor wicks on the coil. Pull one out and put the stem back on and you should be good to go.

 

[v1k1ng1001]

Lower voltage a bit and remove flavor wicks. I like the pt2 but those heads do not like to go hot. It's all about a cool, airy vape. If that doesn't suit you, time for a carto tank or iclear30.

 

[Outcast]

I'm using 80pg/20vg I like the cooler vape so I will stay with PT2 just had to play with it some I played with the bottom ring to let more air in and seems to be working much better

 

[v1k1ng1001]

Good! There is a learning curve to working with the heads on the ptII. Trial and error, you'll figure it out.

 

[crxess]

Actually it has had time to start saturating fully.

We get dozens of post a week from people with the same problem - filling a Bottom coil with a heavy vg mix and thinking it will work right away.
Get a drop of 80/20 on a table and watch it just sit there. VG is rather cohesive and likes to stick to itself. It also is attracted to water.

Next time put a few drops of water on the wick first. It will aid in speeding up wicking.

Removing a wick is the last resort and best to keep the removed piece.you may soon find it has to go back in to stop leaking.