Quad coil

[jarrodb92]

I want to build my igo w6 with quad coils what wire and wick should I use

 

[texanator]

It all depends on your target ohms. If you can stand Rip Trippers on youtube, check this video: youtube.com/watch?v=ZqfbVU8Wedg

 

[rufus1138]

It all depends on your target ohms. If you can stand Rip Trippers on youtube, check this video: youtube.com/watch?v=ZqfbVU8Wedg

+1 on this, i usually want more ohms than most ppl seem to have an obsession with, i would start with a 28 gauge build off of rip trippers model on youtube since his ideas all seem good and sound to me and test it. if its still sub ohm i would bump the wraps up on each coil by 1 or two and see what that does. my initial target would be 1.4 ish tho

 

[bulldog63h]

What device are you putting your atomizer on?

 

[USRN2016]

So, I just built my IGO-W6 in quad coils using 24 gauge Kanthal (following Rip's video). Its hotter than I like and its at .3 ohms. I am going to redo it with 28 gauge Kanthal and see how it goes. I usually use 28 gauge on my RDA's, so I'm pretty sure I'll like that vape better.
My IGO-W6 is on my 26650 Panzer, which performs better than my 18650 Panzer (IMHO).

 

[jarrodb92]

I have an hcigar stingray ss it's not a clone with an 18650 2500 mah battery.