RBA: RSST
Mod: Empire Clone K100
Battery: 18650 (Panasonic)
juice: AiV "CrunkBerry"
So I started out with an AGA-T and I just could get it to stop spitting juice from the bottom of the wick. After a few wicks I was needing a good vape so went back to the DCT. After getting an RSST tonight, I decided to go ahead and drill out the air hole (1/16) and roll my 400 ss mesh. I didnt want to pulse it, so I just oxidized the top part and light burned the bottom going into the tank to clean all the chemicals off. Well I wrapped it 3 times with 30g and was getting .7ohms so I wrapped it once more and now im getting .9ohms. So with 3.7v/.9ohm...im getting 15.21W. The top cap gets pretty hot and it is spitting hot juice specks again! After letting it sit for a while, I am back to it and it doesn't spit AS much but you can still hear it pop. The vapor is is good and thick, almost like inhaling too much thick smoke. Do I need to go up in my ohms to bring the wattage down and maybe this will stop the hot popping juice? I do not have a 2cent fuse and know if I keep it .9 and above and do not feel the button get to warm i should be alright. So my real question is after this back story is.....Is my wattage too high? Could this be causing the hot juice popping? What ohm setting do you guys see work pretty good on this setup? Any help is needed. Also, yes I am aware of the risks of not using a fuse and in the process of getting one.
Thanks guys!
Mod: Empire Clone K100
Battery: 18650 (Panasonic)
juice: AiV "CrunkBerry"
So I started out with an AGA-T and I just could get it to stop spitting juice from the bottom of the wick. After a few wicks I was needing a good vape so went back to the DCT. After getting an RSST tonight, I decided to go ahead and drill out the air hole (1/16) and roll my 400 ss mesh. I didnt want to pulse it, so I just oxidized the top part and light burned the bottom going into the tank to clean all the chemicals off. Well I wrapped it 3 times with 30g and was getting .7ohms so I wrapped it once more and now im getting .9ohms. So with 3.7v/.9ohm...im getting 15.21W. The top cap gets pretty hot and it is spitting hot juice specks again! After letting it sit for a while, I am back to it and it doesn't spit AS much but you can still hear it pop. The vapor is is good and thick, almost like inhaling too much thick smoke. Do I need to go up in my ohms to bring the wattage down and maybe this will stop the hot popping juice? I do not have a 2cent fuse and know if I keep it .9 and above and do not feel the button get to warm i should be alright. So my real question is after this back story is.....Is my wattage too high? Could this be causing the hot juice popping? What ohm setting do you guys see work pretty good on this setup? Any help is needed. Also, yes I am aware of the risks of not using a fuse and in the process of getting one.
Thanks guys!
