RBA A7 SS Mesh?

[Keita]

Will this work? I have a A7 rba and was thinking of using SS mesh to wick. Will it work good? Do i need to put the SS into the reservoir? Or should I just buy a new rba? If so any recommendations for SS? Same goes for tanks as well.

 

[tj99959]

An A7 is kinda small for putting a SS wick in. I doubt that you can do it and have the wick over the air tube.

Also, a wick can not pick up juice that it isn't touching.








<~~ got lots of A7's

 

[Keita]

So which atty would you recommend? Also which tank would you recommend for a SS mesh as well?

 

[Keita]

bump, anyone have any idea?

 

[Keita]

Anyone? A little help would be nice.

 

[Myrany]

well I can't speak to a dripper for SS mesh but I am planning to buy and AGA-T2 which is a genesis clone tank. SS mesh set up on it. See PBusardo's video on the AGA series.

 

[Zealous]

You could build a ss mesh wick for an a7 but it would not pick up any juice that doesn't land on the coil. I do have a mini RDA (also called a mini octopus I think) & I have built ss mesh wicks for it with success. It's a pretty inexpensive atty. I got mine at discount vapers but I've seen it on other vender sites too.

 

[Thrasher]

what you can do is a hybrid using silica wrapped with a small piece of mesh. the silica will draw the fluid but the mesh should give the flavor. or any of the igo's or numbus clones like the v5 will work there is plenty of room for a mesh wick and the wick is diagonal on the posts anyways

 

[dhomes]

it will work, i do it all the time on a modded A& (using for dripping) and a Phoenix

here: matter of fact, this is my fave setup Ninja Vapes

(although I wrap coils directly on mesh & then carefully put in place)