rba deck O-ring for Smok TFV-4

[Cail]

I was just wondering if anyone knows a source or even just the ID/OD for the o-ring that goes above the threads on the rba deck for the TFV-4.

Mine actually tore the first time I used it. I've had more trouble with the rubber components of the TFV-4 between this, the original top-fill rubber being a bit warped, and (on receipt) the initial bottom tank seal being melted onto the glass.

 

[Stinkytofus]

aromamizer from vapenw for 19.99 is a good fix

 

[Old Curmudgeon]

Look on eBay there's some available, also check kidney puncher for the tank o rings.

 

[EverPresentNoob]

aromamizer from vapenw for 19.99 is a good fix

Not sure thats the answer he was looking for, but right now i kinda agree with you... Either that or a Crown.

 

[Cail]

Yeah, I've thought about both of those but right now I'm just trying to decide if I like the TFV4. If it doesn't work out I'll probably just stick with my Subtank Plus for a while. I have only had a couple minor issues with it.

 

[Stinkytofus]

dont get me wrong, TFV4 is an awesome tank if you use their premades, their rca section gave me a very very good vape but for some reason their RBA sections kept on leaking for me, maybe my o-rings are bad, but before you dismiss it OP, try replacing it with the o-rings in the box (the chimney and the one underneath the deck)

if it still dont work out, aromamizer is too cheap to pass up and is a good replacement if you rebuild...

 

[VAP8]

Yeah, I've thought about both of those but right now I'm just trying to decide if I like the TFV4. If it doesn't work out I'll probably just stick with my Subtank Plus for a while. I have only had a couple minor issues with it.

Hi, this is what I wrote on another post:
"But then another design issue: The wide juice channels go down all the way down to the base of the RBA unit, leaving no flat surface for the bottom seal o-ring to sit on, at every screw or unscrew, you are chipping at the o-ring as if with scissors. After a few unscrews you got to change the RBA base o-ring."
this concerns the single coil RBA, the TF-R1, I don't know if that's the one you are using. If you end up liking the TFV4 + TF-R1 RBA, you'll be screwed by the RBA seal o-rings which may give in any time. Even if you have stock loads of them, and they should be cheap, it is still a bugger to have them fail unexpectedly on a tank full of juice.