RDA RDA you can actually unscrew?

[JT!]

Looking for a 5 post rda where the casing doesn't go over the top of the base. I have a mutation x v2 clone right now where that happens and to remove it from my box i have to pull the thing apart and then grab hold of where the o-rings are to unscrew it.

I'm looking for something that is taller and has a section that I can grab hold of and remove the entire thing in one go.

Any suggestions?

 

[ddloco]

Velocity


Sent from my trltetmo using Tapatalk

 

[JT!]

Yeah that's a little better. But the ring still looks very thin.

Any more suggestions? Maybe doesn't have to be 5 post.

 

[Ou2mame]

What about getting a 510 heatsink and removing that with the rda. It leaves your options open and cools your rda too!

 

[JT!]

What about getting a 510 heatsink and removing that with the rda. It leaves your options open and cools your rda too!

I didn't even know this was a thing.

Lifesaver, thanks man.

 

[Ou2mame]

They are on fasttech for 2 bucks. I use one on my aluminum mech to preserve the threads.

 

[JT!]

I bought 20 of them so I can stack them.

 

[Ou2mame]

Cool vape bro.. See what I did there? Lol.. You'll have to post a pic

 

[JT!]

Cool vape bro..

 

[93gc40]

Put a washer or oring, on the 510 and stop tightening them so much.

 

[Ou2mame]

Put a washer or oring, on the 510 and stop tightening them so much.

Sometimes you have to, to spin the cap to adjust the airflow. You can only turn it in a tightening motion, because the other way will just take it off. I put a small amount of electrical tape on the bottom of my mech where the battery sits to add just enough space where when it's screwed together and then I tighten the rda to it, when I unscrew the bottom, the rda is still loose.