Rebuildint Aga-t2 ohm's changing ?

[moijamie]

Hallo all

I bought a aga-t2 a couple days ago but i cant seem to build a good coil every time i test it on my vamo it says low ohm and 2 minutes later it cant 2.4 ohms or 5 ohms it changes out of itself its very strange, any one experienced this before?

 

[Judge Dredd]

The change in ohms is due to a short in the circuit. Be careful when building and test everything. You shouldn't see any shorts if you're careful and do it correctly.

 

[moijamie]

The change in ohms is due to a short in the circuit. Be careful when building and test everything. You shouldn't see any shorts if you're careful and do it correctly.

how can i see shorts? the coils glow nice and evenly from the midle out

 

[Baditude]

how can i see shorts? the coils glow nice and evenly from the midle out

Typically an uneven glow of the coil, or the upper leg of the wire going to the positive post, or the thumb screw on the positive post becomes loose - are the usual culprits. You can't always "see" the short though. If your mod's protective circuitry is reading lo ohms or another error, it is sensing a short somewhere in the coil. Try tilting the wick/coil more toward the positive post and re-adjusting the thumb screw.

The best video that I have seen on working out shorts in a coil was done by Zen, for the ZAP for Provape.

 

[moijamie]

Typically an uneven glow of the coil, or the upper leg of the wire going to the positive post, or the thumb screw on the positive post becomes loose - are the usual culprits. You can't always "see" the short though. If your mod's protective circuitry is reading lo ohms or another error, it is sensing a short somewhere in the coil. Try tilting the wick/coil more toward the positive post and re-adjusting the thumb screw.

The best video that I have seen on working out shorts in a coil was done by Zen, for the ZAP for Provape.

Watched the video and i guess i just gona have to rebuild it and follow what zen is doing