Refilling nautilis mini

Status
Not open for further replies.

Kieferz

Senior Member
Oct 19, 2014
117
176
Louisville,Ky
Maybe I'm doing this wrong but I have noticed more often than not when I unscrew the bottom of my nautilis mini the coil stays screwed into inner tube part. This means I have to unscrew the coil and rescrew it into the base again. This gets messy and takes more time than I would like. Am I doing something wrong? I have found nothing that compares to the mini as far as I'm concerned with the taste and throat hit but it's a royal pain in the rear to fill.
 

GeorgeS

Ultra Member
ECF Veteran
  • May 31, 2015
    2,266
    3,534
    Oregon, USA
    Maybe I'm doing this wrong but I have noticed more often than not when I unscrew the bottom of my nautilis mini the coil stays screwed into inner tube part. This means I have to unscrew the coil and rescrew it into the base again. This gets messy and takes more time than I would like. Am I doing something wrong? I have found nothing that compares to the mini as far as I'm concerned with the taste and throat hit but it's a royal pain in the rear to fill.

    I've done that before. I think you may be tightening the base to much.

    1st while you have the base off make sure the coil is on tight then when you re-attach it remember that you don't have to 'wrench' it down until it won't move, just keep turning until it is 'snug' or just bottoms out and you should be good to go. After a while you'll get a 'feel' when you have 1/4 turn or so left that does not need to happen.
     

    Traijan

    Super Member
    ECF Veteran
    Verified Member
    Jun 24, 2014
    541
    353
    USA
    That use to happen to me all the time on my full size Nautilus.

    The way that I got around it was to make sure to open/refill the tank before it got to only 1/3rd juice full. If I let mine drop below about 1/3 +/- it became a bear to even unscrew the glass tank from the bottom and usually ended up leaving the coil screwed into the tank.
     
    Status
    Not open for further replies.

    Users who are viewing this thread