Reo mini sparkling spring collapse/ replace sparkling again.
- Thread starter bydus
- Start date
- th_trl_thread_readers 0
- Status
Did you pull off the atty or cartos you were using?
You need to take off that atty or cartos and try a new one.
Do you have a multimeter?
You need to take off that atty or cartos and try a new one.
Do you have a multimeter?
Last edited:
Either a bad atty/carto or the insulator ring may have gotten "crushed" and is shorting out.
I would clean everything well, meter an atty to make sure its good and try again with it just lightly finger tight.
If you have any problems you know Rob is here to help you out.
Good luck.
I would clean everything well, meter an atty to make sure its good and try again with it just lightly finger tight.
If you have any problems you know Rob is here to help you out.
Good luck.
Take out the battery and see if you can clean that little tip with a swab and maybe some iso alcohol. See if the black goes away. If you have noalox put a little dab on that tip.
Do you have a multimeter?
Do you have a multimeter?
As Tim said usually when the spring collapses it is the fault of the atty or cartos. A multimeter would let you check the atty you take off and let you see the reading.
Make sure the atty or cartos you were using when it happened is tossed!
First thing you should do if you get any sparking is remove the atty or cartos that is on.
Sometimes just tightening the atty or cartos while putting it on can cause a short. Always make sure they are held straight when making contact with the connector.
Always check the bottom of the atty or cartos. The center ring should not protrude out.
Glad it is now working for you!
Make sure the atty or cartos you were using when it happened is tossed!
First thing you should do if you get any sparking is remove the atty or cartos that is on.
Sometimes just tightening the atty or cartos while putting it on can cause a short. Always make sure they are held straight when making contact with the connector.
Always check the bottom of the atty or cartos. The center ring should not protrude out.
Glad it is now working for you!
The sparking your talking about is fixed with a clean contact or a drop of noalox .If you smoke another spring please send the mod to me it does however seem you had a bad carto . Keep us or me informed
You should think about a mulitmeter. I check every atty and carto prior to using them. You can get them as cheap as 5 dollars.
- Status
