congrats, you made a great choice. when I first got my 2.0 I thought how could this thing me good, its way to small.
I was wrong it worked nice and its a easy build base too.
after a couple days I did realize I needed a larger air hole for my vaping technique and my coil. I increased the air hole size little by little
and stayed with the new size a couple/few days before I went larger. now, its vaping outrageous. big clouds. really great flavor and I love it.
Woot woot I'm excited. My first rm2 and first rba on its way.
Just thought I'd share my excitement.
If it goes well, I'll have to get another one so Reo grand doesn't get jealous of the Reo mini
Sent from my iPhone using Tapatalk
An RM2 with a micro coil around .9-1.4 ohms will suit you rather well I think. Super easy to build and will give you great flavor and clouds with thin wire that won't back out your post screws. Get some 30g kanthal and do a 8-9 wrap coil with the sterile cotton and you will love it, get great battery life, and have a Vape that isn't stupid hot like something in the .4 ohm range.
Woot woot I'm excited. My first rm2 and first rba on its way.
Just thought I'd share my excitement.
If it goes well, I'll have to get another one so Reo grand doesn't get jealous of the Reo mini
Sent from my iPhone using Tapatalk
I think the stock is almost perfect. I have opened a couple of mine up just a little.....not to the full 1/16" that a LOT of Reonauts are running. But then, I don't do sub-ohm coils, either. I vape at between .8 and 1.1 ohms and the stock air hole is fine. I'm not sure how it compares to other attys/cartos because I just can't remember. the RM2 is in another league altogether. Try it stock at first, then you'll know whether or not you want to open it up a little. You're gonna love it.....!!!
Stock air hole works for me at between 0.8 and 1.3. Looking forward to hear about your experience with the RM2.
Quick question to everyone, how is the stock air holes? I am very keen on the boge LR and Empire atomizer draw. Is it comparable to those ?
Sent from my iPhone using Tapatalk
I felt the draw was airy compared to the atomizers I used. Took a little while for me to get use to it.
The drip tip you use will contribute to the draw also. Some of the large bore drip tips will make it more airy.
I have a few drip tips that are small bore. I do like those better.
Also if you do lung hits you might find a large bore drip tip gives you more air flow.
And what atomizers were you using ? This wil help me gauge the draw a little better
Peace
Sent from my iPhone using Tapatalk
hi, bhamilton_930
I posted a reply earlier today, and you asked me how I inhale. I do mouth to lung. my go to coil set up is .8 ohms with 28 gauge wire
and the coil is 4 wrap.
I do and have tried dual coils in my rigs. and going to lower ohms. low as .3 ohms. for some reason .8 gives me the warmth I like and the vape cloud I like along with very good flavor from my juice.
I have had good results with dual coils and with more wraps with a smaller diameter coil. but I always return to my 4 wrap .8
I don't remember what size the air hole I ended with on my reomizer, but I like a little draw, I don't need to fill a room with when I exhale. but I do like the vape to be on the thick side.
later on you asked to compare the draw of a stock hole with a carto or pre made atomizer. I used empire mods atty's before and many cartos and I feel the stock hole is a tighter draw then premade atty's and cartos. but it all personal.