So I'm on a quest to find the perfect carto seeing as the Boge 2.0's have been having problems lately.
I bought 15 of the Resurrectors from CCV. They're great on the initial fill, but within a day or so they tighten up to the point where they're almost unusable. Anyone know of any ways to prolong their demise or make it better?
I tried sticking a pin down in a few of them and it worked on one or two, the rest didn't respond. If you try and look down the middle of the cartos you can BARELY see light, if at all. This bothers me because the Boge's you could always see right through the center. I also tried making sure the air holes are clear, but the draw is tight even when they aren't screwed into anything so I'm pretty sure the problem lies inside somewhere.
I also tried blowing them out.. seemed to make it a hair better but nothing crazy.
These things seem like they have the potential to be great, but they gotta last longer than a day without issues..
I bought 15 of the Resurrectors from CCV. They're great on the initial fill, but within a day or so they tighten up to the point where they're almost unusable. Anyone know of any ways to prolong their demise or make it better?
I tried sticking a pin down in a few of them and it worked on one or two, the rest didn't respond. If you try and look down the middle of the cartos you can BARELY see light, if at all. This bothers me because the Boge's you could always see right through the center. I also tried making sure the air holes are clear, but the draw is tight even when they aren't screwed into anything so I'm pretty sure the problem lies inside somewhere.
I also tried blowing them out.. seemed to make it a hair better but nothing crazy.
These things seem like they have the potential to be great, but they gotta last longer than a day without issues..
Last edited: