Review of the Target PM80
- Thread starter Vaporesso_Milo
- Start date
- th_trl_thread_readers 0
- Status
Those 4 colored rubber plugs, they are not meant as replacement for the fill hole, but for the airflow adjustment, correct?
Because I could not find anything in the manual, but they exactly fir with the airflow holes.
good they are included, look it to most with one airflow valve closed
Good job on this pod-mod, really nice.
any plans for a RDTA/RBA?
Hi, great design, not so great execution. I own 6 Vaporesso mods, 3 of them are PM80. All 3 PM80's leak juice into the well. Two have stopped powering on with the fire button, must plug in charge cable to turn on. Even then it comes up set at 5w, can be adjusted but settings won't keep. Need to mop up leaked juice with every fill up. This has to be my fourth or fifth message about this problem. Is juice seeping into the electronics compartment causing trouble? Is this leaking a design flaw? What is V aporesso doing about this? I'm not the only on having these identical failures.
Looks great, can't wait to receive mine to write a review
You should have received yours by now, has it started leaking yet? Does it still power up with the fire button or do you need to plug in the charge cable? I have 3 only because I was a Vaporesso buyer for a long time and usually satisfied with their products. This one is a swing and a miss, all three leak and the first two won't power up with fire button.
So sorry for your trouble and bad experience. Did you contact our Customer service already? Kindly contact for warranty here Contact Us » Vaporesso. And we will definitely forward your feedback to our engineers first to look into and figure out the problem asap
Thanks for the reply. Did that weeks ago. What's the status of my request for warranty replacements?
Please message us your email address so we can confirm with our customer service team, thank you
- Status
Similar threads
- Locked
- Locked
