Riva cone

[Richie G]

I'm looking for a specific item, the Riva cone BUT for the 901 atty NOT the typical 510. The 901 cone is about 1/2" shorter in length than the 510 cone. I don't see anything but kits at Liberty Flights and it's not worth it to buy from East Mall with such a small order.

Anybody know where I can get some from a USA vendor?

 

[mistinthewoods]

Hi Richie. Do you have a Riva or an Elegant or Defender? The Riva comes with a native 510 connecter. I use 808 cartos and 901 attys on mine but I need an adapter for those. The adapter makes the carto or atty stick out of the cone 1/4" further so it works fine with a regular cone. Altsmoke has the cones in stock. AltSmoke.com | Personal Vaporizers | Electronic Cigarette | Ecigs | Riva Ecig Ego
Here's a link to the adapter I use on my Riva and my other 510 native devices. 510 to 901/808-D Adapter

 

[Richie G]

Thanks for the thought, Mist. =) But I think you misunderstood.

The Riva does indeed come in a native 901 option, not that I have one, mind you. LOL The cone on this 901 Riva is short, about an inch long. My plan is to utilize this cone on the eGo with the LR306 atty w/drip tip. The 510 cone is too long to work with the 306 atty drip tip combo.

Electronic Cigarette - Starter Kits - Riva 901

So, now to find a USA based vendor...

 

[MaxUT]

There's an outside chance you could get an Elegant Easy cone from Cig Easy. I sent Pocket Aces a PM to ask, since I'd like to try one.

Larger pic showing short cone:
Photo Gallery

Electronic Cigarettes from Cigeasy - Home of the Easy E-Cigarette

 

[Richie G]

Shameless bump for attention...

 

[Ease]

I ground (grinded) about 3/4" off of the end of my riva cone and it works like a charm with the lr306. Allows for good airflow and catches excess juice. I used an 8" grinder but another member here used his dremel with a cutoff wheel and grinder attachment.

 

[Katya]

A sheet of #220 sand paper work wonders, for the low-tech folks, like me.

 

[Richie G]

I ground (grinded) about 3/4" off of the end of my riva cone and it works like a charm with the lr306. Allows for good airflow and catches excess juice. I used an 8" grinder but another member here used his dremel with a cutoff wheel and grinder attachment.

Bingo. Which is exactly what I'm trying to achieve.

But, I don't want to widen the aperture by grinding/cutting/sanding off the taper of the cone... I'd like this to fit tight around the outside of the atty, like normal. The short 901 cone would do that, no fuss, no muss.

I can't believe that I have to order from the UK or from China for a couple of 901 cones?

Anyone? Anyone? Bueller?