RDA Rounded grub screw. Freakshow..super duper angry!

[JayWer]

JUST got a Freakshow last night and set it up for a single coil. So I didn't loose the screw for the post I wasn't using I just screwed the screw down just flush with the tip of the post. This morning I decided I would set it up with one of my favorite builds, a simple twisted positive dual. Go figure the screw was jammed and began rounding out at the hex. Does anyone have any tips or suggestions for getting it out? I'm livid in a way one can not fathom. Like Hulk smash livid. It was an exchange because I got a Lancia earlier yesterday at the B&M because the clear mid cap/sleeve was just too tempting and the chimney stacks for the air flow that press into the deck would not stay snug. A slight tap and they fell right out. I exchanged it for the Freakshow in which I had to pull teeth to get them to agree to even exchange it and fell in love with it, but now I cant use it to its fullest potential!

 

[Brandon David]

Drimmel across the head with a cut off wheel and use a flat head? Not sure if it will work since he screws are so small.




Sent from my iPhone using Tapatalk