Show me a good 22mm BF capable topper

[Coastal Cowboy]

I build for the power the particular DIY likes and the atty it will be ran in. Normally for my DLH's that's dual coil low Ω builds in most of my gear (0.12Ω-0.18Ω). But the flavor is stellar with this build and ceramic wicking in this atty on a Pico Squeeze I take when I go out to run short errands in the wee hours of the night. Makes enough flavor rich vapor yet is easier on the limited on board joose supply so I don't have to take a refill bottle along.
26-316L-4mm-5w-0.45Ω-RxW. The RxW is what makes this high Ω build work for this DIY.

You had me up to the RxW part.

I think I still have some of that stuff around here...

That's a fat coil for the Wasp. How's the flavor?

 

[Coastal Cowboy]

Struck the rock twice.

 

[Spydro]

You had me up to the RxW part.

I think I still have some of that stuff around here...

That's a fat coil for the Wasp. How's the flavor?

READYxWICK - READYxWICK

The 4mm coil easily fits in it, and doesn't restrict the air anymore than the small AFC slots and the Wasp Nano's cap tip already do. You could use the 2.7mm RxW if you want a smaller diameter coil. I used to use some of my 2.7mm in the past (but never did use the 1.7mm I bought). I want big wick to hold big joose for my big lung hits.

From above... "the flavor is stellar with this build and ceramic wicking in this atty..."
RxW is flavor wick.