Sigelei 150w ohm reader accuracy

[jj6404]

I just got my sigelei 150w and I'm questioning the accuracy of it's ohm readout. Now granted no $15 ohm reader is that accurate, the one I have has come pretty damn close to what steam engine has predicted for a while now. So is my ohm reader more accurate or is my sigelei?

For instance, I have a build that's reading a steady 0.3 ohm on my reader, but it always reads 0.2 on my sigelei. On another atty, I've got a build that reads 0.21 on my ohm reader but it always says 0.1 on my Sigelei. Now I would get it if it rounded up, but why would it round down?

Has anyone else had experience with this mod being so far off from your ohm reader?


Sent from my iPhone using Tapatalk

 

[MattyTny]

I wouldn't call it so far off. A 0.1ohm difference isn't too big of a difference. As long as you are making good contact and no jumping reading I wouldn't worry too much about it.

I have the Sigelei 150 too and anything pretty low isn't that accurate I found. My 0.38 reads 0.3, but my 0.5 reads the same on the ohm reader and the Sig.

 

[Dioxyde]

I seem to remember hearing that the accuracy of the reading begins to drop significantly with builds lower than .5 or so. Don't think I've experienced that but I don't usually build lower than .5.