SLBs in review

Status
Not open for further replies.

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
As most of you know I was waiting with much anticipation the delivery of the 510 2Ohm atty to give it a whirl on my eGo. I should have read my own charts LOL.

I was never a fan of LRs to begin with, although they have their appeal in certain circumstances, but they were not the end all be all of vaping, to me anyway. I enjoyed the 1.5Ohm on the eGo but did not use the eGo because operating a proprietary $30 battery (Canada Prices) did not make a lot of sense, when knowing the battery would be stressed. The eGo being capable of 1.5A and the 2Ohm atty having a 1.55A draw, put a smile on my face. Switched ya dummy, you need to look at both charts.

Low and behold the 2Ohm runs far too cool on the eGo but performs well at 3.7V on an 18650 delivering 6.8w compared to 4.8w. The draw on the only 2Ohm I got is a little tight, similar to vaping with the cone on the eGo, so that is cool. The draw is too tight on the eGo. Because I vape the eGo with cone fitted exclusively, and the heat produced insufficient, the LR 510 has been relegated to the Precise for the time being.

I received an HV 901 a the same time, ahhhhh, thank you Isaac. I was wondering what all the hooplah was all about wrt the 901 atty. I did not like 901s in the past, and found the atty too finicky, always bordering on being flooded or wouldn't wick worth a damn at 3.7V, and only performed slightly better at 5V. Well that might be a 3.7V but not at 6V. I spent the entire time available from a set of LifePO4s, dripping it :D TH was decent and vapour production more than adequate. I least now I have renewed faith in the 901. A cooler vape with a soothing throat hit and great flavour, as a 901 should.

The LR 801 shorty. Good vapour production but runs a little on the hot side for me and my vaping style. I absolutely love the aesthetics of the unit. This is a winner aesthetically speaking. I want to give this atty the run for it's money. I have only been using it with RY4 at this point and the delicate bouquet of RY4 is not shining through in comparison to its bigger brother. I will be switching juices and see if it improves.

I would definitely like to see this atty developed in 3.5 and 5.2 Ohms, I believe it would be a hard item to keep in stock. Mind you, the proxixity of the coil to the lips (heat), may not be suitable at high voltages or pleasing to some.

This short review is entirely subjective IMHO. Depending on what criterias folks based their vaping nirvana on. The entire SLB line is a quality product and performs extremely well as intended, where intended. Being that I prefer to vape in the vacinity of 6-8 watts, make most of my reviews on HV highly subjective, and I apologise for that. Some folks look for heat, I simply don't. So please do not read into this more than is necessary.
 

Iken

Unregistered Supplier
ECF Veteran
Jan 23, 2009
7,011
4,882
PA,USA
Wow Switcher! I swear man, every time I finish reading one of your reviews on any product, I just want to stand up and applaud you and rush out to get one!I'm not blowing smoke here, but more so vapor!
applause.gif

It really is comforting to know that the 901 is appealing to you. As it keeps breaking-in, it really starts to shine. We do carry the 5.2Ω 801 and due to the sweet airflow it preforms lovely on 7+ volts. I'll inquire more into a 3.5Ω Hv version. It is worrisome about the proxixity of the coil to the the user, but then again with the higher resistance they don't get very hot.
 

Iken

Unregistered Supplier
ECF Veteran
Jan 23, 2009
7,011
4,882
PA,USA
A la Elvis: Thank you, thank you very much.

I just say it as it is. I am glad folks like my comments, sometimes they are negative but I always try to say why. BTW ECF crashed on me my friend almost at the end of a long reply re: your long PM. I will get back to it Isaac, just not tonight.

Oh no! Always right click>copy before hitting the submit the button. Happens all the time and is such a darn nuisance. About any negative comments, you do justify them totally and unconditionally. Criticism is always what's needed and I'm sure people see it as help and guidance, more so than "This guy is just mean!" Atleast, it should be taken as informational :oops:
 

VaporMadness

Ultra Member
ECF Veteran
Jan 26, 2010
1,521
7
CA, USA
Isaac's 2ohm attys hit the spot for my 3.7v vaping. I don't do std ecig batts any more as they don't have the juice to drive these things to their fullest, never did eGo's for the same reason.

I haven't tried all that many other LR attys, but I have sampled a couple other BE 2ohm attys. Isaac's are a cut above those in terms of both vapor production and flavor production if you ask me. I think the effort Isaac has put into identifying the appropriate parameters has paid off.

There is some variance in the individual IkenAttys I've received (good luck finding a supplier w/o variance). A couple have been "too hot" initially and tended to scorch liquid if I wasn't careful, but they tempered after a few days and all was good. Personally, I'd much rather they be "too hot" then "too cool" right out the gate. One of my LR510s just doesn't want to take liquid thru the mesh bridge, an oddity that makes use with carts difficult, all of the others have been cart friendly.

The only 901 that I have that hasn't leaked thru the side hole is my Iken LR901, so I really like that one above my other 901s. That particular atty is a real flavor/fog machine. The ONLY reason I haven't gotten more of the LR901s is my previous experience with that atty design leaking from that hole in the side. I've like how all of my 901s have vaped, and the LR901 even more so.

My first (and only so far) LR801 was in prime time exclusive heavy use for 3.5 weeks solid. The only reason I set it aside was to more easily sample a handful of new flavors that I had received. Busted open a couple of new LR510s to do the sampling. One Iken/DSE and another BE. The Iken atty is easily my preference (better flavor and better fog). I'll put the LR801 back into service at some point, but for now I'm rotating the two LR510s (but leaning more heavily on the Iken atty).

I have more IkenLR801's in transit right now, and when these 510s start to wane, I'll be looking for some more Iken LR510s too. These IkenVape 2ohm attys are Goldilock's favorites.
 

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
I haven't tried all that many other LR attys, but I have sampled a couple other BE 2ohm attys. Isaac's are a cut above those in terms of both vapor production and flavor production if you ask me. I think the effort Isaac has put into identifying the appropriate parameters has paid off.
Definitely paid off. I can see that, or is it taste that, I guess both LOL

There is some variance in the individual IkenAttys I've received (good luck finding a supplier w/o variance). A couple have been "too hot" initially and tended to scorch liquid if I wasn't careful, but they tempered after a few days and all was good. Personally, I'd much rather they be "too hot" then "too cool" right out the gate. One of my LR510s just doesn't want to take liquid thru the mesh bridge, an oddity that makes use with carts difficult, all of the others have been cart friendly.
... and although I believe I was careful is what happened to my shorty 801. I like the notion that perhaps it will cruise in to becoming a champ. As I said I need more time to put that sucker through it paces. The LR 510 is settling in nicely and has loosened up some. Wrt atty variance I hear you my friend...

I have more IkenLR801's in transit right now, and when these 510s start to wane, I'll be looking for some more Iken LR510s too. These IkenVape 2ohm attys are Goldilock's favorites.
LOL I still remember the story LOL. I have quite a stash of attys but yes as time goes by they will be replaced with Ike's SLBs. Providing he doesn't get screwed like some vendors, he/we have some winners here for sure. We need some 3-3.5 mid range 801s which I use at 5-6V. My latest batch suck buffalo balls, and I mean big time. As this batch dwindles I may go with the 112s, and give them a whirl. I have heard great reports about them from the community.
 

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
I believe you will be pleased with them.

On another note, my trip to Montreal was conducted with 3x 510 cartos on the P18 (longevity) and the eGo. The brand new flue cured carto wound up on the eGo a it was too airy on the P18. Man I love those cartos, they were purchased for the trip :) and didn't deceive me (not that I thought they would).

On another even more positive tangent, my sister is please that I quit smoking and is cool that I vape in her house :D I will be enjoying my vacation. I was plugging away on some blackberry menthol last night and found the smell quite appealing.
 

Iken

Unregistered Supplier
ECF Veteran
Jan 23, 2009
7,011
4,882
PA,USA
Absolutely! Very glad you made it with flying colors to boot.
Speaking of these 2.0 atoms (They have been preforming beautiful btw) I have been using them on the Ego and have found a slight difference in comparison to the standard Joye 2.2Ω. The 1.8-2.0 is just a notch closer to satisfaction.

I still owe you some Switcher. Would you like to have a treat waiting home for you upon your return? or Would you like to me wait to ship for when your ready?
 

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
Absolutely! Very glad you made it with flying colors to boot.
Speaking of these 2.0 atoms (They have been preforming beautiful btw) I have been using them on the Ego and have found a slight difference in comparison to the standard Joye 2.2Ω. The 1.8-2.0 is just a notch closer to satisfaction.

I still owe you some Switcher. Would you like to have a treat waiting home for you upon your return? or Would you like to me wait to ship for when your ready?
Eyes going to be hootin & tootin with the Toronto gang :) Our own little vapefest :D

Yes you do :) just set them aside along with some 510 cartos (20 total):
  • 5x stainless
  • 5x white
  • 5x black
  • 5x green
...and ship all together. You will be receiving an order sometime next week for the cartos, so please ship all together, saves you on shipping a back order. The 2.0 LR is breaking in nicely at 3.7V, too cool for the eGo. I'll note it in the comment box.
 

Iken

Unregistered Supplier
ECF Veteran
Jan 23, 2009
7,011
4,882
PA,USA
Hey Isaac, you should trick him and ship him a bottle of Nutella, :)
e2954b35.gif
We were grocery shopping 2 days ago and had to stop at the big jug of it and just Laughed!

Eyes going to be hootin & tootin with the Toronto gang :) Our own little vapefest :D

Yes you do :) just set them aside along with some 510 cartos (20 total):
  • 5x stainless
  • 5x white
  • 5x black
  • 5x green
...and ship all together. You will be receiving an order sometime next week for the cartos, so please ship all together, saves you on shipping a back order. The 2.0 LR is breaking in nicely at 3.7V, too cool for the eGo. I'll note it in the comment box.
Sir yes sir! Would you like the current Slb's carto's or the latest when they come in? Thank you for the consideration my friend. WooHoo via Vapefest!! You Better of brought your camera!
 

Switched

ECF Guru
ECF Veteran
Feb 18, 2010
10,144
2,544
Dartmouth, NS Canada
e2954b35.gif
We were grocery shopping 2 days ago and had to stop at the big jug of it and just Laughed!


Sir yes sir! Would you like the current Slb's carto's or the latest when they come in? Thank you for the consideration my friend. WooHoo via Vapefest!! You Better of brought your camera!
The old one`s are fine indeed Isaac. I know what to expect and I am a creature of habit
 
Status
Not open for further replies.

Users who are viewing this thread