No problem, I'm glad they were able to help you get a build in it. Personally I would have gone with .5 ohms or higher with your device. You'd get more coil surface and can dial up your wattage a bit more, but that's just my preference. I get better flavor and vapor production with higher coil surface area. If you're at .35 ohms, I'd say run it around 20-25W if you're getting dry hits at 30W.
I'm the wrong person to ask that question. I stopped using cotton a while back and haven't regretted it for a second.
Yep, I've had the same coil/wick set-up in my Silver Play for over a month now. No changes to it at all. But I don't use cotton, the wicks in my build are rayon. I just hit 300 mL this weekend... that's what temp control + rayon will do for you.
If juice is coming out from around the glass, then you need to break it down, check your o-rings, and tighten things up. The only reason it would leak around the glass is either a bad o-ring or it's not screwed together tight enough. I fill from the bottom through the little screw. I use a needle tip dropper bottle. Sometimes there will be a little air gap, most of the time not... either way, it's not going to hurt anything, and at 1/8 inch, you're only missing maybe 1/4 mL. Don't sweat the small stuff, man...
