Smoant Pasito 25W - RBA POD
- Thread starter ArminF
- Start date
- th_trl_thread_readers 0
- Status
i running 1.0-1.3 ohm coil with 13-16w, density of cloud is slight lower than smok nord but flavor n throat hit is decent.
i bought myself second pasito, it seem like they change charging performance.
First pasito:
0-60% charge at 0.98a
60-85% charge at 0.77a
85% charge at 0.1-0.15a.
it take nearly 1 hour to reach 90% (4light n fifth blink) 9XX MAH and 1 hour n 15 minute -30 minute for 1XXX MAH.
Second pasito:
0-95% 0.77a
95% charge at 0.4a.
First pasito:
0-60% charge at 0.98a
60-85% charge at 0.77a
85% charge at 0.1-0.15a.
it take nearly 1 hour to reach 90% (4light n fifth blink) 9XX MAH and 1 hour n 15 minute -30 minute for 1XXX MAH.
Second pasito:
0-95% 0.77a
95% charge at 0.4a.
Last edited:
strange, I wonder if its battery issues, cable differences, or chipset.
i think they make some change on chipset and i forget to measure charging time, will update tomorrow.
I got my Pasito since a few days and just got my RBA and tested it out with cotton bacon, 28g kanthal, 5 wraps which is a bit above 1 ohm. Running it on the third light which should be 16w and 9mg freebase nicotine.
Throat hit and vapor production is great, about the same as my subtank mini in which i run the same configuration.
The flavor is also about the same but i got a bit of a cold so my taste buds aren’t functioning properly yet. It got a bit more flavor compared to my Artery Pal II on the 0.6 ohm mesh coil.
Throat hit and vapor production is great, about the same as my subtank mini in which i run the same configuration.
The flavor is also about the same but i got a bit of a cold so my taste buds aren’t functioning properly yet. It got a bit more flavor compared to my Artery Pal II on the 0.6 ohm mesh coil.
2nd light is just a bit too soft for me but the third light is about ok. The fourth light which is 20w hits a bit too hard 
Chain vaped for a few minutes an no dry hits. I have wicked the coil like Mike Vapes did in his review (dam method).
Chain vaped for a few minutes an no dry hits. I have wicked the coil like Mike Vapes did in his review (dam method).
How is the air flow on the Pasito? Does it go down to a real tight draw? Most of the YouTuber videos use it DL. I am curious on how and where the air gets to the coil.
I vape MTL with about 20-30% of the airflow open. It is tight enough for me. Fully closed is quite tight but your mileage may vary as everybody has his/her own preferences.
i am really liking this device thus far. Especially because it is rebuildable and there are 5 wattage settings and airflow control. Time will tell how it will behave on the longer run. I have used it just one day and it is not my primary vape device.
One con is that it floods when refilling with the RBA as mentioned by Sonnycool. I haven’t tried any of the stock coils yet so i don’t know if the flood is RBA specific.
Perhaps i will buy a second one just like Sonnycool
if i like it on the longer run.
i am really liking this device thus far. Especially because it is rebuildable and there are 5 wattage settings and airflow control. Time will tell how it will behave on the longer run. I have used it just one day and it is not my primary vape device.
One con is that it floods when refilling with the RBA as mentioned by Sonnycool. I haven’t tried any of the stock coils yet so i don’t know if the flood is RBA specific.
Perhaps i will buy a second one just like Sonnycool
if i like it on the longer run.
Last edited:
i found another issue, on air flow side a bit of leaking but i think smoant is try to address that issue now ....I vape MTL with about 20-30% of the airflow open. It is tight enough for me. Fully closed is quite tight but your mileage may vary as everybody has his/her own preferences.
i am really liking this device thus far. Especially because it is rebuildable and there are 5 wattage settings and airflow control. Time will tell how it will behave on the longer run. I have used it just one day and it is not my primary vape device.
One con is that it floods when refilling with the RBA as mentioned by Sonnycool. I haven’t tried any of the stock coils yet so i don’t know if the flood is RBA specific.
Perhaps i will buy a second one just like Sonnycool
btw more cotton does solve flooding issue for me.
My build crapped out when i went out for shopping today. Suddenly it shorted and then it worked and it stopped working again.
I had to rebuild when i was home. I could not determine what the real problem was but probably a loose connection on one of the posts. The current build is still working fine and no flooding yet after the first refill.
Luckily i had a justfog minifit with me otherwise no vaping for a few hours
I had to rebuild when i was home. I could not determine what the real problem was but probably a loose connection on one of the posts. The current build is still working fine and no flooding yet after the first refill.
Luckily i had a justfog minifit with me otherwise no vaping for a few hours
Last edited:
How goes it since the above experience? I also was wondering how long the wick and wire last on that tiny little deck. Hopefully you're still enjoying it. I'm still really interested, but the vape budget doesn't quite allow it just yet.
Second build is still doing ok. A bit under 1 ohm and no flooding yet when refilling and no crapping out.
I don’t use it as my main device though. I only use it when i go out so i cannot say anything yet about longer term usage.
One thing i can say is that it uses quite a lot of juice. More than my Artery Pal II with 0.6 mesh coil or my mod with Subtank Mini RBA 1.0 coil.
I vape with the second and third wattage setting on my Pasito. Flavour is really great though.
I don’t use it as my main device though. I only use it when i go out so i cannot say anything yet about longer term usage.
One thing i can say is that it uses quite a lot of juice. More than my Artery Pal II with 0.6 mesh coil or my mod with Subtank Mini RBA 1.0 coil.
I vape with the second and third wattage setting on my Pasito. Flavour is really great though.
So I can see the device for sale, as well as either 3 coils in a pack or the RBA section in a different pack. I do not I do not see the replacement tanks for sale in case you want to have a few different flavors going at the same time. Are they available?
It is an ongoing issue, in the UK too.
Believe it or not, for my Frenzy, I had to sweat to find the only one reseller which stocked spare Frenzy pods, among literally hundreds of webshops. Previously I had the same issue with the Biip.
I don't know what is going on. Possibly many vape shops are just shifting boxes, and are fixated with unsold items, or sold too slowly. Or that the pod device reveals to be a flop and they are left with a bunch of unsellable accessories.
That is the nature of the vape business, surprise bananas which can ripen in a day or in a month - only the manufacturers knows when.
As rule of thumb, with my latest "splashing" on pod system, I carefully avoid buying from shops that doesn't carry all accessories; but that's me; other vapers may prefer - reasonably so - to buy from lowest price shops, deferring the purchase of extra pods into near future, if and when will be required, needed, or liked.
Truly, this avalanche of devices has left me somewhat jaded and disappointed...
Believe it or not, for my Frenzy, I had to sweat to find the only one reseller which stocked spare Frenzy pods, among literally hundreds of webshops. Previously I had the same issue with the Biip.
I don't know what is going on. Possibly many vape shops are just shifting boxes, and are fixated with unsold items, or sold too slowly. Or that the pod device reveals to be a flop and they are left with a bunch of unsellable accessories.
That is the nature of the vape business, surprise bananas which can ripen in a day or in a month - only the manufacturers knows when.
As rule of thumb, with my latest "splashing" on pod system, I carefully avoid buying from shops that doesn't carry all accessories; but that's me; other vapers may prefer - reasonably so - to buy from lowest price shops, deferring the purchase of extra pods into near future, if and when will be required, needed, or liked.
Truly, this avalanche of devices has left me somewhat jaded and disappointed...
Base on smoant customer service reply,they redo/redesign pasito pod, in asia some pod having serious leaking issue.
I still waiting update from them.
@SonnyCooL - thanks.
Very interesting. Guess I'll be waiting a bit longer before I consider this one.
Very interesting. Guess I'll be waiting a bit longer before I consider this one.
So i got one yesterday. I had asked my local shop to get them and the owner did, along with a couple RBAs for me. I built one last night and didn’t find it to bad, though a little tougher due to post hole alignment. I noticed with the RBA filling was a little more difficult and it takes up more room in the tank. It was vaping fine and took it to work. While driving I had it in my hand and apparently the button was against my center console and it was firing, so cotton burnt a little, glad I had my Orion to switch over. At home now and emptying tank is a PITA and I had to break out a hypo to do it. Replaced cotton and back in business.
I got it specifically for the RBAs. I have 2 Orion’s that are my ADV and have gotten tired of buying pods and waiting on someone to make an RBA for them. However, if it happens, I’ll get one as I love my Orion’s.
This Smoant is OK, it is bigger than the Orion, but lighter, and doesn’t seem like it’s built like a tank like my Orion’s are. We will see. I hate the swirly panels and drip tip and would have preferred just simply black panels. I don’t know what to think of the Usb C, as it’s my only anything that uses it, so now I need to find some longer cables. The Orion charges faster it seems, but it is a smaller batt I guess. Haven’t tested batt life on Pasito yet, but it’ll happen when I can get through a day without burning my ato.
I got it specifically for the RBAs. I have 2 Orion’s that are my ADV and have gotten tired of buying pods and waiting on someone to make an RBA for them. However, if it happens, I’ll get one as I love my Orion’s.
This Smoant is OK, it is bigger than the Orion, but lighter, and doesn’t seem like it’s built like a tank like my Orion’s are. We will see. I hate the swirly panels and drip tip and would have preferred just simply black panels. I don’t know what to think of the Usb C, as it’s my only anything that uses it, so now I need to find some longer cables. The Orion charges faster it seems, but it is a smaller batt I guess. Haven’t tested batt life on Pasito yet, but it’ll happen when I can get through a day without burning my ato.
- Status
