Smok X cube II

[MorbidPleasure]

What's up fellow vapers?

Today I hot my hands on a smok X Cube 2, man this thing is nice. 160w Temp Control, VW, and Bluetooth. Yes, Bluetooth.... it's used for an app on Android and IOs. It gives temp, watts, number of puffs taken, how long each puff was ect. Anyways, I'm not sure how accurate the app is but I have this thing set to 160w yet on each hit I'm not getting any higher than 75w. Still chucking the clouds.

Right now I have my royal hunter rda with a dual Macro set up, Kanthol 26 Guage at 0.47ohms.

Anyone know what might be going on?

 

[Romano Cheese]

Greetings and welcome @MorbidPleasure I don't have a Smok X Cube 2 but I have seen threads for it you may want to use the search function and see if you can find them. Not sure but if you set it to 160w it should put out that amount, unless you are in temperature control mode. Temperature control does not work with Kanthal - Nickel or Titanium only.

 

[NealBJr]

What's up fellow vapers?

Today I hot my hands on a Smok X Cube 2, man this thing is nice. 160w Temp Control, VW, and Bluetooth. Yes, Bluetooth.... it's used for an app on Android and IOs. It gives temp, watts, number of puffs taken, how long each puff was ect. Anyways, I'm not sure how accurate the app is but I have this thing set to 160w yet on each hit I'm not getting any higher than 75w. Still chucking the clouds.

Right now I have my Royal Hunter RDA with a dual Macro set up, Kanthol 26 Guage at 0.47ohms.

Anyone know what might be going on?

How does it cook steak? that sounds good right about now...

The device probably has an amp limit. On some TC mods, the higher wattages are only for the temperature control wires, and the lower ohms.

Just punched in those numbers in ohms law calculator... you're putting almost 6 volts into those coils... you trying to start a fire in your atomizer? I bet it's real warm in there. Perhaps it limits the voltage to 6 when using non TC wire.

 

[Romano Cheese]

@dcfluegel has one of those I'm sure he can answer these questions. This is out of my league.
Smok X Cube II/ first impressions | E-Cigarette Forum

 

[dcfluegel]

howdy - and welcome!

for starters, not sure i would run 160w on a .47 ohm build... what kind of batteries are you using in your Cube 2? and what mode are you in? temp, wattage or memory?

 

[dcfluegel]

are you setting wattage on app or on mod?

 

[MorbidPleasure]

Right now I'm using 2 efest 18650, on watt mode, changing it via the box.

 

[dcfluegel]

which efests? i specifically chose sony vtc4 batteries for mine, based on the cdr (continuous amp discharge rating) - efest may not be best batteries for high power usage - somewhat notorious for being re-wraps and overrating their amp capabilities...

 

[MorbidPleasure]

It's an Efest I'm 3.7v li-MN 35A High Drain.

 

[ThatGuyIvory]

It's an Efest I'm 3.7v li-MN 35A High Drain.

While 30A ones are just fine, 35A have a lot worse discharge rate than 30A version apparently. They have surprisingly bad reviews so I'd recommend to swap them. Regarding the 160W - I believe you'll have to drop down the ohms a bit to reach that 160 as I think you're reaching volts capacity at (as you mentioned) 75W. So your watts will go up (on the screen) but you'll notice volts staying in place. That's a bit of a guess but when I got my hands on a 100W device I encountered the same thing. Oh well, the more you know.

 

[dcfluegel]

yah - 160 watts on .47 ohm build would exceed the 8volt listed max output

 

[Yarael]

I just got one the other day. Love it so far. Haven't tried the TC yet as no shop where I live has Ni200 wire or coils for anything. Hopefully I can get some. Right now just using my Subtank Plus with the RBA at around .6 ohm around 30 W working great.

 

[TamiVapes]

What's up fellow vapers?

Today I hot my hands on a Smok X Cube 2, man this thing is nice. 160w Temp Control, VW, and Bluetooth. Yes, Bluetooth.... it's used for an app on Android and IOs. It gives temp, watts, number of puffs taken, how long each puff was ect. Anyways, I'm not sure how accurate the app is but I have this thing set to 160w yet on each hit I'm not getting any higher than 75w. Still chucking the clouds.

Right now I have my Royal Hunter RDA with a dual Macro set up, Kanthol 26 Guage at 0.47ohms.

Anyone know what might be going on?

Good FSM, how much was that?! Could we get a hand check pic?

 

[LiquidDave]

The Xcube doesnt have wattage mode in TC. Just soft medium and hard. What kind of batteries do you use?

 

[MorbidPleasure]

This thing is nice. Thanks for the replies. Now have this thing at maximum capacity. With 0.18 ohm quad coil setup. Straight CHUCKING.


Edit: sorry I forgot to put a price lol. $70 on Fluid Vapes.

 

[MorbidPleasure]

Never said I was running it in TC, I simply said it has TC capabilities.

 

[DonnyX]

Just got my X Cube II today and I've got to say it's well made and it's gonna take some time to get used to.

Sent from my iPhone using Tapatalk

 

[ffrank]

Hey guys.. I just signed up so I can't make a topic. I'm having trouble unlocking titanium mode with the x cube 2. I enter my mastercard info and it says they don't accept this payment type. Has anyone else had this problem?

EDIT: Sorry, I didn't realize I could post a new topic in the New Members forum.. Please disregard this message.

 

[Crawfyj09]

Temp control sounds like its kicking in although you said your using kanthal yes? If so thats probably saving you somewhat from one nasty as dry hit haha

 

[drugarth]

My biggest issue: you seem to have to use the app to set temp coefficient to be able to use TC.....and well it's only android and apple...so with my windows phone/tablet no TC....so definitely a no buy for me