Hi there.
I’ve tried few different set up on this one for past couple days, with SS mesh U shape, SS mesh + silica combo, dual coil with SS.… It’s tricky to place the coil over the original air hole. Dual coil using original airhole is impossible, little vapor and inhumane TH.
So far I like the one below the best, quite close to the Phoenix RA (got 3 authentic & 3 knock off, they replaced my HR 510 and 306 attys for daily use) performance.
Wick hole: 7/64 (tip: drill a 5/16 hole on a wood piece, fit the battery connector in there. Now you can hold it down firmly)
Air hole: 1/16 (and seal the original air hole. Tip: drill with slow speed)
The plastic isolating piece: cuts down the chamber volume by ~40% (tip: soak in hot water before cutting)
took one coil out from the dual coil setup (man, I had both at 2.8-2.9)
how it is now
the closer airhole to the coil, the more vapor and smooth TH
Pls input your idea of improvement and recommendations
I’ve tried few different set up on this one for past couple days, with SS mesh U shape, SS mesh + silica combo, dual coil with SS.… It’s tricky to place the coil over the original air hole. Dual coil using original airhole is impossible, little vapor and inhumane TH.
So far I like the one below the best, quite close to the Phoenix RA (got 3 authentic & 3 knock off, they replaced my HR 510 and 306 attys for daily use) performance.
Wick hole: 7/64 (tip: drill a 5/16 hole on a wood piece, fit the battery connector in there. Now you can hold it down firmly)
Air hole: 1/16 (and seal the original air hole. Tip: drill with slow speed)
The plastic isolating piece: cuts down the chamber volume by ~40% (tip: soak in hot water before cutting)
took one coil out from the dual coil setup (man, I had both at 2.8-2.9)
how it is now
the closer airhole to the coil, the more vapor and smooth TH
Pls input your idea of improvement and recommendations
Last edited: