so no-one got back to me on a post in RBAs

[drifter17x]

Any tips on the igo l . Never built a coil and never dripped before. I got 3 mm silica wick.32 g kanthal. A kts mech and a vamo. Never used either of them. Just a spinner and mvp. Any advice on what to use the igo with and what not to? If I wanna get 1.5 ohms how many wraps do I need? 5?6?

 

[syeroc]

On 3mm wick with 32g kanthal I usually end up with around 2.2-2.4ohms with 5 wraps. Yours might be slightly different if you wrap tighter or more loosely than I do. Experiment with it. I would try all your new coils on the Vamo first though. Because it has built in protection. Unless you use a 2cents-for-safety fuse on the mech mod. But why chance popping your fuse.

 

[drifter17x]

Very true . So the tighter the wrap....what occurs and the looser the wrap... What happens then?

On 3mm wick with 32g kanthal I usually end up with around 2.2-2.4ohms with 5 wraps. Yours might be slightly different if you wrap tighter or more loosely than I do. Experiment with it. I would try all your new coils on the Vamo first though. Because it has built in protection. Unless you use a 2cents-for-safety fuse on the mech mod. But why chance popping your fuse.

 

[djtonyb]

longer wire = more resistance.

 

[D. Waterhouse]

Get a muti-meter, build a coil, test it w/ the meter. Never! do a first run on an electronic mod, use a mechanical mod with an IMR battery. Always test with a meter first. Don't run anything lower than 1.5ohm until you have some experience and knowledge. Check out some of these videos for more info.