Spicy Altoids

[Rockalot]

This is a 5 volt reg chip bottom feeder (16 ga blunt stainless) with a tactile switch. sorry the pics are so bad.

I modified Dreams compression washer and moved it up a bit to be a juice catcher and it works. I used a 3x aa box and dremeled it out on the left side. Just enough to hold the bottle tight.

It hits like a truck and the feed seems to work well but 510 cartomizers draw tough. Attys work great. I might try a smaller needle if I ever build another..

Thanks to Joker/Dreams N Chains/Huffheinz and all the other modders that showed me how to do it.

All supplies from madvapes the hardware store and Amazon.

My first mod my gal and I made together.

 

[asdaq]

Very nice work indeed. For a 510 carto I like the 18G, mounted somewhat lower. If the needle is still movable, try setting it just above the pos terminal in the connector (or trim it). This is a good mod for explaining to people the how-it-works of vaping.

 

[Connman]

Great job Rockalot.
Fine looking Gal or I mean mod.
A juice feeder in a Altoids tin nice and 5 volt that`s just plain awesome. Also that`s one sharp decked out mod in that last picture.

I can`t seem to stop using my tin boxes for holding my atomizer rebuilding supplies and work in progress stuff.
One of these days though.

 

[5cardstud]

Dang, You do nice work. That is a sweet Mod. I really like the other one too. Very artistic.

 

[jctennis]

20 gauge hypodermic needle tubing works great with cartos.

 

[mi528hz]

I will have to try and make one just for fun.

 

[Rockalot]

Thanks guys! It was a lot of fun building it. I never could have done it without all the good input on this forum.