Hey guys hope you all good today.
I am currently making a stabwood box mod and I am stuck with making my battery contacts spring loaded, I have found these "spring loaded contact pins" but these in the link I have provided are rated at 9amps. I am not very confident on the electrical side of things so I hope someone could advise if 9amps is not even close to what I need, or would these 9 amp pins be ok because the current isn't continuous in a mod?
The chip I will be using will probably be the dna 250, will the answer to my question depend on how high in watts the mod can go?
https://www.newark.com/mill-max/0871-0-15-20-82-14-11-0/contact-spring-flat-10-16mm/dp/46X8067
Thanks in advance guys
I am currently making a stabwood box mod and I am stuck with making my battery contacts spring loaded, I have found these "spring loaded contact pins" but these in the link I have provided are rated at 9amps. I am not very confident on the electrical side of things so I hope someone could advise if 9amps is not even close to what I need, or would these 9 amp pins be ok because the current isn't continuous in a mod?
The chip I will be using will probably be the dna 250, will the answer to my question depend on how high in watts the mod can go?
https://www.newark.com/mill-max/0871-0-15-20-82-14-11-0/contact-spring-flat-10-16mm/dp/46X8067
Thanks in advance guys
Last edited: