Stainless steel rope?

[pleaselah]

Does anyone have any experience with them? where can i get them from?

thought of either wrapping ss mesh around or fitting it through silca wicks, any comments?

would be using it on either ihybrid or noble 1

 

[pleaselah]

http://ebay.com

just wondering if this would work, intending to get some to try

 

[roosterado]

With SS Cable for wick 2-3 ft lasts a long time. A 1 i+ inch wick can be used for months,just change out the SS Mesh at the top and the coil when needed. Be sure to torch the SS Cable wick well before using first time

Stainless Steel Cable Wick - AtomizerWick.com

 

[pleaselah]

With SS Cable for wick 2-3 ft lasts a long time. A 1 i+ inch wick can be used for months,just change out the SS Mesh at the top and the coil when needed. Be sure to torch the SS Cable wick well before using first time

Stainless Steel Cable Wick - AtomizerWick.com

thanks a lot for your help and recommendation !

i was just wondering, my ihybrid's wick hole is approx 2.9mm, should i get the 2mm or 2.5mm diameter rope?

TIA

 

[roosterado]

I would go with the 2.5 2.5mil cable is really about 2.6-2.7 mils so it should fit a 2.9 mil wick hole Oh it takes a heavy duty wire cutter to snip off a piece I got mine at a large hardware store for about $16 I do not know if a dremel tool would work

 

[pleaselah]

I would go with the 2.5 2.5mil cable is really about 2.6-2.7 mils so it should fit a 2.9 mil wick hole

thanks buddy, really appreciate it

 

[roosterado]

thanks buddy, really appreciate it

Yor Welcome Gennies are great once you get the build down my Dewalt Wire Cutter http://www.amazon.com/Dewalt-Diagon...m_sbs_e_3?ie=UTF8&refRID=17QERBDXC9BERZ8AMMZG