Subtank Mini v2 and Higher VG

[Vaping_Racoon]

Hi,

I'm looking to try juices from Vapor Jedi who do 70/30 VG/PG blends for their stock.

I'd like to know if it is easy to do such a thing with the rebuildable atomizer that I use.

Is there a tweak when building? Right now I use Fiber Freaks #2 Cotton with 5 wraps of 26 Kanthal.

Thanks alot

 

[TheotherSteveS]

you should be fine. I run 80%VG with no problems in both V1 and V2 rba heads...

 

[sig-cmt]

Same here, running 80 VG with both heads (updated PEEK insulators w/ bottom juice channels + Mini RBA Plus w/ side juice ports) though I do need to keep wattage and temps lower than I normally would.

 

[Vaping_Racoon]

Thanks for the heads up guys but what about the build? Do you do the same as mine?

thnx again

 

[tedigram]

Yeah, agreed. Never had any issues with high VG in the mini, the highest I've vaped in it was 80VG. Though, that wasn't true when I used a 2mm coil for a while. That was just too small to keep up with chain vaping. No problems with 2.5 and 3mm coils though.

 

[Vaping_Racoon]

Yeah, agreed. Never had any issues with high VG in the mini, the highest I've vaped in it was 80VG. Though, that wasn't true when I used a 2mm coil for a while. That was just too small to keep up with chain vaping. No problems with 2.5 and 3mm coils though.

Do you mind describing your build a little (gauge, number of wraps) ?

 

[tedigram]

Fair warning, I've basically had perma-vaper's tongue since I started, still dulled by the cigarettes, so I'm not a great judge on how a build is doing flavor-wise. I tried to build for maximum flavor, but can't really judge how successful I was.

But as far as simple performance and vapor production, I settled on 2.5mm 28 gauge double twisted, 6-7 wraps that usually clocked in at around .6-.8 ohms. I went back and forth between contact coils and spaced, but did spaced most of the time because I felt like the contacts were getting gunked up too quickly. Positioned low on the deck to get as close to the airflow as possible and minimize spitback, and wicked pretty loosely inside the coil. I usually ran it around 22-25 watts on my MVP3 pro.

 

[Vaping_Racoon]

Okay man, thanks for the info. I'll probably ask around the vape shops, I might find
something good for that kind of use.