Svoë Mesto Kayfun III ES Discussion/Questions
- Thread starter BoyNamedStacy
- Start date
- th_trl_thread_readers 0
- Status
There's a whole thread on them in the new members section.
Sent via the guys that made Star Trek low tech.
I was rebuiding my kayfun 3.1 and somehow the threaded section of my kayfun air duct pole was broken. A portion of the threaded section is now left inside the positive pole. I was searching on the net for the air duct pole replacement parts but could not find any.
I will very very much appreciate if anyone can provide a link on where to find it.
Thanks guys.
I will very very much appreciate if anyone can provide a link on where to find it.
Thanks guys.
Are you referring to part 2h?
http://www.meshweaver.com/temp/vaping/SVOEMESTO_KAYFUN_v3.1ES_USER_MANUAL.pdf
You may have to email svoemesto directly
Little late on this suggestion, but about the hot juice problem. I had the same thing going on, so I cut a circular piece of 400x400 mesh and just dropped it in to the top before screwing on the mouthpiece. Solves the issue for me.
Still finding this to work well? Hasn't caused any issues sitting on top of the coil?
Plug the air hole with your thumb and open the top cap and look.
No problems at all. It's a long way from the coil. Sorry for the crummy picture, but this is the top where the mouthpiece goes, so it's all the way above the tube that screws on over the coil.
Currently using a cotton wick with a 11 wrap of 30g @ 2.5ohm with the air flow screw removed. It's not an open draw because of the size of the air hole inside the atomizer but it's a very nice vape.
I'll have to give that a try. I may move it to the chamber at the top by the drip tip. I usually get some juice built up there after a couple tanks so I'll keep that as a collection chamber rather than keeping everything in the atomizer.
EDIT: Oh wait, that's exactly what you're doing. You're a thinking man.
Last edited:
I've only gotten it that full with a syringe (or otherwise using the fill port). I end up with ~3ml if I fill from the top.
with a few parts, you could get it to hold 15 ml lol
http://electra-pipes.com/en/svoemesto/531-slug.html
watch video 1/2 way down the page
In extra long mode & a mod with a 18650 battery, it would be HUGE! lol
http://electra-pipes.com/en/svoemesto/531-slug.html
watch video 1/2 way down the page
In extra long mode & a mod with a 18650 battery, it would be HUGE! lol
Last edited:
Im sure some of u moght know this but just in case.....
I went to disneyland today, vaping on the way there... Parked my car and thought i should just leave my mod and kayfun in the car.. I didnt want to leave it out in the open,( for the direct heat and it getting stolen) so i put it in the middle console. Covered it with a towel. 4 hours later on this warm day, i get back and grab myod.. Yes it was warm, and liquid was coming out of the kayfun lites airhole.. I vaped it and a lil gurgleing.. I guess with the heat it changed the pressure so it leaked..
Now im thinking of bringing along a cooler to keep it in on my car trips
I went to disneyland today, vaping on the way there... Parked my car and thought i should just leave my mod and kayfun in the car.. I didnt want to leave it out in the open,( for the direct heat and it getting stolen) so i put it in the middle console. Covered it with a towel. 4 hours later on this warm day, i get back and grab myod.. Yes it was warm, and liquid was coming out of the kayfun lites airhole.. I vaped it and a lil gurgleing.. I guess with the heat it changed the pressure so it leaked..
Now im thinking of bringing along a cooler to keep it in on my car trips
Im sure some of u moght know this but just in case.....
I went to disneyland today, vaping on the way there... Parked my car and thought i should just leave my mod and kayfun in the car.. I didnt want to leave it out in the open,( for the direct heat and it getting stolen) so i put it in the middle console. Covered it with a towel. 4 hours later on this warm day, i get back and grab myod.. Yes it was warm, and liquid was coming out of the kayfun lites airhole.. I vaped it and a lil gurgleing.. I guess with the heat it changed the pressure so it leaked..
Now im thinking of bringing along a cooler to keep it in on my car trips
Super hot right now in so cal too. I can imagine that thing was leaking.
Actually the Kayfun was crying because you didn't bring her to Disneyland, just used her for the ride. Shame on you.
Super hot right now in so cal too. I can imagine that thing was leaking.
Actually the Kayfun was crying because you didn't bring her to Disneyland, just used her for the ride. Shame on you.
LoL, ahhh so what i mistook for juice leaking was actually tears running down... Im going again today and thanks to u i'll bring her along...
This is my all time favorite atomizer. So I put a review together on video. Enjoy.
Some how I lost track of this thread.
My Mini is now in the hands of my wife. At least it went to a good cause- she is vaping more, and smoking less.
Anyways, I need to replace it. I have been trying to decide between another mini, or a 3.1. If anyone has experience with both for a comparison, I would really appreciate some advice.
Thanks.
My Mini is now in the hands of my wife. At least it went to a good cause- she is vaping more, and smoking less.
Anyways, I need to replace it. I have been trying to decide between another mini, or a 3.1. If anyone has experience with both for a comparison, I would really appreciate some advice.
Thanks.
- Status
Similar threads
