SX350 Firmware Update Troubles

[cl1ffhuxtable]

Hello everyone, I am new so I have to post here instead of the appropriate forum, hopefully someone can help.

I have recently acquired an SX350 based box mod that had already had the 50w update applied and I wanted to complete the final firmware to enable 60w. I was having some connection issues with my Windows 7 computer and the software updater but I got that sorted out and the mod updated. Here are the odd things I have noticed:

- My up/down physical buttons do not change the wattage anymore. The only way I can change the wattage is in the preset menu and with the gravity controls.

- My battery readout is sporadic to say the least. Even when the LED shows green and the battery should be full I am not showing anything in the visual bar and the voltage is usually in the low 3's.

I am not quite sure what to do at this point. Does anyone have any suggestions?

Thanks

Mike

 

[JohnD0406]

I have recently acquired an SX350 based box mod that had already had the 50w update applied and I wanted to complete the final firmware to enable 60w.

Did you use the SX350 firmware, and not the SXmini firmware? The latter is specific to the SXmini only.

 

[Sthur]

Here is a post with some good comments on 350 updating.

http://www.e-cigarette-forum.com/forum/modding-forum/562076-yihi-sx-350-firmware-upgrade.html

You might try and update it again. Check youtube for some upgrade vids.

 

[bonmatos]

To just do a reset with the menu link

you go on link on the menu (without connected usb cable) you inclined and remains tilted until the reboot of the screen