Tauren Solo

[rob33]

I'm really loving this new Solo I got. Anyone got a good mechanical build for it.

 

[Mordacai]

What mech and battery are you using @rob33? As it would be helpful to know.

And, also what resistance are you used to using?

 

[rob33]

When I got the rda also got a Tauren Max, also use a Dreamer and a box squonker with Vapcell 20700s 3500 mah 30A. My RDAs were Hadalays. I mostly run around .5Ω with a smaller gauge fused clapton.

 

[Mordacai]

No worries.

I think that you can go as low as about 0.2 ohms due to the massive amount of airflow, but I'd think that around 0.3 ohms may be a better fit for your vaping habits.

And can the mod with the 20700 take a 21700?

 

[AngeNZ]

When I got the RDA also got a Tauren Max, also use a Dreamer and a box squonker with Vapcell 20700s 3500 mah 30A. My RDAs were Hadalays. I mostly run around .5Ω with a smaller gauge fused clapton.

I'd try it first with your standard coil. If it's not enough, get some fused clapton wire with an extra core eg instead of a tri-core fused clapton - get quad-core.

 

[mimöschen]

Because of the massive air intakes the Tauren Solo is more suited for lower and more complex builds imo.
A 26*3/38 Fused Clapton, 3mm ID, 5 wraps, .21ohm performs quite nice.