Tcr for 316L on aegis mod

[aalmosawi]

So I have made some coil that's from a 316L wire and was wondering what proper value to put in my aegis.

The resistance is 0.59....

I also like a warm vape. What temp is good and what wattage is optimal?

SS316L - Stainless Steel Round Wire - EVEN GAUGES

 

[Tonee N]

0.0092

Sent from my SAMSUNG-SM-G891A using Tapatalk

 

[ScottP]

So I have made some coil that's from a 316L wire and was wondering what proper value to put in my aegis.

The resistance is 0.59....

I also like a warm vape. What temp is good and what wattage is optimal?

SS316L - Stainless Steel Round Wire - EVEN GAUGES

TCR has been answered for the other questions, I would start at 25W and 450F, If the ramp up isn't fast enough, up the wattage. If the vape isn't warm enough up the temp.

Personally I vape SS316L 0.5 ohms at 30W but only 435F.

 

[Coastal Cowboy]

Single or dual coil build?

If it's a single, you'll probably like it where @ScottP has it. If it's a dual, about 40 Watts is a good place to start and 430 F for a temp.

Airflow is important too. With a new build I start open full and work back if necessary.

 

[KenD]

So I have made some coil that's from a 316L wire and was wondering what proper value to put in my aegis.

The resistance is 0.59....

I also like a warm vape. What temp is good and what wattage is optimal?

SS316L - Stainless Steel Round Wire - EVEN GAUGES

There should be a ss tc setting. Those are commonly set for ss316l wire. You shouldn't need to set up a separate tcr unless the pre-programmed ss setting is off.

Sent from my Thor E using Tapatalk