Temp Control Issues

[Nconway2709]

Good evening guys! Just have a quick question here and hopefully I can get this figured out fairly quick. I'm running a Cloud Chasers Inc Triforce Subohm tank on a ipv 3Li and currently have a Ni200 coil in here and have set my ipv 3Li to temperature control mode. My settings are 50 joules, 550 degreees, 0.29 Ohms. For some reason it's not wanting to hit right, the Volts keeps fluctuating and it starts low and goes higher when I hold the fire button down. Not really giving me a good hit like the 0.2 ohm kanthal coil did. Any ideas on what's going on or what I'm doing wrong? Thanks guys!

 

[sultanofswag]

Possible bad connection on your coil. What happens if you try a lower temp, say 450 or a bit less?

 

[Nconway2709]

Same exact thing happens. Maybe I should pull the plug off of the bottom of the coil and see if the two leads are positioned in the right way? I'm just not exactly 100% sure how they are supposed to be positioned.

 

[sultanofswag]

This a pre-made cartridge coil, not one you made yourself on an RTA deck (this tank can use either, so just want to clarify)? If so, try a different one and make sure you prime it.

 

[bigrf85]

i have that issue with my triforce tank on ipv4 but it works loads better on a dna 200 device at a high wattage in temp mode i dont think 50 joules is enough to push through the massive coil the triforce has never have been able to use the ni coil effectively on an ipv device but seems to be power hungry even in temp mode

on the other hand a ti or ni coil in the upgrade/rba section works fabulously in my opinion