Temp control over a .1?

[H3artl3ss696]

Trying to get a temp control rda going but can't get over the .1 I need for my rda to work on my Sigeli 150 temp control box. Anyone had any luck with temp control rda on nickel wire?


Sent from my iPhone using Tapatalk

 

[Adrian Ludvik]

I'm pretty sure the 0.1 minimum resistance is for non Tc.

 

[H3artl3ss696]

Reading through the manual that's what I thought but I can't get it to work when I go into the temp control mode.


Sent from my iPhone using Tapatalk

 

[BlueridgeDog]

Some chips come out of TC mod when the resistance is seen to be above a certain point. We are to a point that high resistance TC builds can have a similar resistance to low resistance non TC builds and a mod that relies on resistance ranges to make that call is going to have problems. The new DNA200, theoretically, does this by testing the resistance variation of the coil to decide if it is a TC coil or not.

 

[TheotherSteveS]

Trying to get a temp control RDA going but can't get over the .1 I need for my RDA to work on my Sigeli 150 temp control box. Anyone had any luck with temp control RDA on nickel wire?


Sent from my iPhone using Tapatalk

which rda? what wire guage you have?? Input input...

 

[H3artl3ss696]

26 and 28, standard coils. Waiting for my 32 to get in so I can attempt to do a Clapton. It's a Hellboy RDA Quad post.


Sent from my iPhone using Tapatalk

 

[TheotherSteveS]

ok. so whats the problem? You want to dual coils right?? That is the problem! Easy fix is use titanium!

btw the sig 75W is 0.05 ohms - hard to believe the 150W is different to be honest!

 

[H3artl3ss696]

Hmm...fair enough. New to the temp control thing so I'll try that now. Thanks!


Sent from my iPhone using Tapatalk

 

[rythus]

I was under the impression that the Sig 150tc didn't support Ti.

 

[BlueridgeDog]

I was under the impression that the Sig 150tc didn't support Ti.

All TC mods support Ti...some do it natively others force you to fudge the set temp.

 

[crxess]

Ti Resistance is wider. You need to run lower Temp settings. 400F, maybe 280F instead. It will still be 400F in production.

Sigelei .1ohm minimum is definitely for Power Mode vaping, not TC.