~The Billet Box~ page 1559 continued...

Status
Not open for further replies.

Uncle

Resting In Peace
Supporting Member
ECF Veteran
Verified Member
Jun 15, 2011
32,527
116,452
"My" Personal preference is the Bridge with BVC Coils (so easy & really nice), however if Ya' have a lot of carto's available that "You" want/need to use up - I find an extra punched hole/s help with the draw . . . Just Sayin' . . . ;)
 

HBcorpse

Vaping Master
ECF Veteran
Verified Member
Jul 23, 2013
4,378
14,477
I'm in! Snagged a nice bright green one. TMNBB. Also picked up the Billet Bridge Nautilus. Need to research as I'm not 100% as to which Aspire coils I can use with that.

Good job!!!

You can use the Nautilus coils, and the Triton Mini coils.
 

DPLongo22

"Vert De Ferk"
ECF Veteran
Verified Member
Dec 17, 2011
32,969
182,766
Midworld

Mike Geaney

Super Member
ECF Veteran
Verified Member
Jul 29, 2014
731
4,342
Boston
Good job!!!

You can use the Nautilus coils, and the Triton Mini coils.

Thanks. I was in a clicking frenzy so I just went with it.

Make sure they say NAUTILUS BVC. Such as:
Nautilus Replacement Cotton Coils - *BVC* - 1.8ohms - 5 Pack

You may want to shop around, but those are the correct coils. Be careful not to get the "X" ones by mistake. Nautilus BVC only.

Will do and thank you. I am familiar with those coils from my Kabuki and Nautilus tanks.

Time to stock up!
 

meleemark

Senior Member
Verified Member
Apr 18, 2015
70
177
Toronto
I can't fathom this at all. 1.9? I agree with DPL on this one and would recommend testing that batt on a good multi-meter.

That just sounds so off to me. :?:

Do you by chance have a Provi to perhaps test it on?

Ill run the battery again and check it with multimeter.
 

stanleybb50

Ultra Member
ECF Veteran
Verified Member
Apr 13, 2011
2,133
7,363
43
Pittsburgh
Ill run the battery again and check it with multimeter.
I'm gonna run mine down too. I'll throw it on a Provari 2.5 when it's done. I'll report back.

On another note, I have a Ratbald on the way now!! Woohoo!! Probably end up selling my Fawkes at some point...

Sent from my SM-N930V using Tapatalk
 

stanleybb50

Ultra Member
ECF Veteran
Verified Member
Apr 13, 2011
2,133
7,363
43
Pittsburgh
Congrats on the TMNBB and the Ratbald!


:shock:
Thanks! And... Maybe not.. It is a Unicorn after all... Haha. :)

And since I can't (would NEVER) "make money" or "flip" it - I'll probably never sell.. :)

Sent from my SM-N930V using Tapatalk
 
Last edited:

Krisma

Vaping Master
ECF Veteran
Verified Member
Jul 4, 2014
8,800
46,582
Australia
Does anyone have experience with the VVTF rebuildable Nautilus heads? I have a couple on order and plan to use them in my BB, and also in a Kabuki .. any tips or tricks appreciated.


I have one and its tiny. Which for me is a struggle. I used for a while but I went back to rebuilding the normal nautilus coils. A simpler method and a consistent result.
 

Kelt.

Senior Member
Supporting Member
ECF Veteran
Verified Member
  • Apr 22, 2014
    164
    728
    Ohio, USA
    I have one and its tiny. Which for me is a struggle. I used for a while but I went back to rebuilding the normal nautilus coils. A simpler method and a consistent result.
    Did you experience any improvement or decrease in flavor? any problems with juice flow or connectivity? does it need any finagling to work with the billet bridge?
     

    Krisma

    Vaping Master
    ECF Veteran
    Verified Member
    Jul 4, 2014
    8,800
    46,582
    Australia
    Did you experience any improvement or decrease in flavor? any problems with juice flow or connectivity? does it need any finagling to work with the billet bridge?

    I never got to the point of using it with a bridge. Things only make it to my billet boxes after I work out all the niggles. It was used in a kabuki and nautilus tank.
    I tootle puff with fairy vapes (2 secs) and menthols, so I am more concerned with easy to use. My menthols are all about icy TH and sensation rather than taste and yes this worked for that. Maybe a tad warmer.
     

    Kelt.

    Senior Member
    Supporting Member
    ECF Veteran
    Verified Member
  • Apr 22, 2014
    164
    728
    Ohio, USA
    I should add that my eyesight is not the best so even with a magnifier......it's tricky
    I experience the same situation. I use a cheap magnifying headgear, and so far it seems to work fine. I wonder about securing the coil head to make it solid whilst building... maybe a vice would serve
     

    Krisma

    Vaping Master
    ECF Veteran
    Verified Member
    Jul 4, 2014
    8,800
    46,582
    Australia
    I experience the same situation. I use a cheap magnifying headgear, and so far it seems to work fine. I wonder about securing the coil head to make it solid whilst building... maybe a vice would serve


    I used the kabuki base and stand
     

    Katdarling

    I'm still here on ECF... sort of. ;)
    Supporting Member
    ECF Veteran
    Verified Member
    Jan 25, 2011
    32,582
    167,751
    Utopia
    Does anyone have experience with the VVTF rebuildable Nautilus heads? I have a couple on order and plan to use them in my BB, and also in a Kabuki .. any tips or tricks appreciated.

    I have one that was gifted to me. I've looked at it, then put it back in the cupboard. :rolleyes:

    From most everything I've read, people's experience have been LESS than stellar with it. Evidently, it's a long and epical lesson in frustration. I'm not sure spending an enormous amount of time attempting to build it and make it work would be worth it for me.

    Strike that. I AM sure.

    Good luck to you, Kelt. I do hope you can make it work!
     
    Status
    Not open for further replies.

    Users who are viewing this thread