I kept looking at the mods on the web and on the fourms, and I wracked my braing trying to come up with something that I haven't already seen.
Finaly,... just before I feel asleep one night the idea hit me.
A simple DiY box mod that supported multiple attys without the need for adapters.
So I set off with my extensive electronics experience,.. <cough,....unnecessary,.. this is simple>
Parts used:
1 Altoids tin
1 AA Battery holder
1 momentary on button
1 slide switch
1 LED
1 470 Ohm 1/8 watt resister
1 Joye 510 connector
1 DSE 801 connector
1 DSE 901 connector
wire

Its hard to see here, but all three heads are hot at the same time. No switching required. (not recomended to run more than one head at a time)

http://img651.imageshack.us/my.php?image=dscf0035j.jpg
I used some "Tail light replacement" plastic and some aluminum tape to hide the wireing. In an emergency it can be easily removed for repairs. I custom fit a piece of foam in the extra space to hold two extra carts.
(510 and 901 attys can also fit, but the 801 is to big to store in the case)

Added graphics


And good to go.
I'd add picks of it vaping each of the heads, but I'm not yet in possesion of the 14500 battery for it.
(I was able to temp wire a 10440 in to verify that the LED and all three heads work.)
Finaly,... just before I feel asleep one night the idea hit me.
A simple DiY box mod that supported multiple attys without the need for adapters.
So I set off with my extensive electronics experience,.. <cough,....unnecessary,.. this is simple>
Parts used:
1 Altoids tin
1 AA Battery holder
1 momentary on button
1 slide switch
1 LED
1 470 Ohm 1/8 watt resister
1 Joye 510 connector
1 DSE 801 connector
1 DSE 901 connector
wire

Its hard to see here, but all three heads are hot at the same time. No switching required. (not recomended to run more than one head at a time)

http://img651.imageshack.us/my.php?image=dscf0035j.jpg
I used some "Tail light replacement" plastic and some aluminum tape to hide the wireing. In an emergency it can be easily removed for repairs. I custom fit a piece of foam in the extra space to hold two extra carts.
(510 and 901 attys can also fit, but the 801 is to big to store in the case)

Added graphics


And good to go.
I'd add picks of it vaping each of the heads, but I'm not yet in possesion of the 14500 battery for it.
(I was able to temp wire a 10440 in to verify that the LED and all three heads work.)